Jump to content
SAU Community

Recommended Posts

It's my understanding that SR20s and RB20s used the same coilpacks (sauf the # needed of course).

Anyone confirm this? I've got Rb20 Splitfires i want to use on an SR, and just want to be sure. I've heard both yes and no to this question.

thanks.

what sr20 is it, becoz some ran a dizzy, even then youd wanna be 200% sure itl work, coz u could burn out the transistor pack and the ecu if your wrong.

Well it doesn't really matter what SR it is (its Crower 2.2), the splitfire coilpacks are good for all 32s-33s, and same with the SR packs s13s and up.

Are these the same Coilpacks though. It would seem so, but i want to know if anyone's sure or not

as long as they aren't the 'Series 2' kind with the igniter built in (which they wouldn't be if they're for an RB20), they should be fine

Series 2 hey? what application would that be? Splitfires for the RB were good for all Rb20, 25, 26 etc, they were a one model fits all. Same with SR ones, CA-SR, 13, 14 etc

If i was to buy OEM coilpacks for my SR20, are the same ones RB20s use?

as used on RB25's without the igniter module

if your SR20 has an igniter module, then it'll use the same coils as an RB20

Ya thats what i figured, but i wanted to double check,

I appreciate the prompt replies though, :merli:

It's my understanding that SR20s and RB20s used the same coilpacks (sauf the # needed of course).

Anyone confirm this? I've got Rb20 Splitfires i want to use on an SR, and just want to be sure. I've heard both yes and no to this question.

thanks.

no chance.

from memory the sr20 coils are much longer than the rb ones, so as status said, i don't think they are going to come close to fitting. i think they will be about an inch too short. all the RB motor ones are short stubby little things.

Series 2 hey? what application would that be? Splitfires for the RB were good for all Rb20, 25, 26 etc, they were a one model fits all. Same with SR ones, CA-SR, 13, 14 etc

If i was to buy OEM coilpacks for my SR20, are the same ones RB20s use?

Think your find they were'nt mate

They are different for spec one to spec two engines

This is ALL the spec two coil packs will fit and years

DSCF1935.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...