Jump to content
SAU Community

Recommended Posts

Hi All,

i have a few bits and pieces out of my half cut and out of my gtst shell. everything open to offers.

also stripping half cut so anything u can think off that i havent listed just ask.

Everything out of R32 GTST Type M

will get picks up soon or can email.

Untouched front reo $50

Type M factory side skirt $250, couple of scuffs nothing to major.

3 headlights all mint

2 RH $75ea

1 LH $75

Rear inside side trims (mint) $50pair

Clutch & brake pedal plus clutch pipes (Master&Slave cyclinders leaking) $75 all (can supply new slave for $58)

Dash (mint) $120 with good vents

Climate control unit $20 also have wiring and a/c mode box (offer$$ and il remove)

Instrument cluster $100 (140,xxxkms)

LH lower control arm $50 (ball joint good)

Washer bottle with both motors $25

r33 RB25 crossmember $60

MDU front coilovers $250 base height adjustable, 17 dampner

6 CA18det coilpacks with plugs $50

Located on the sunny coast qld

pm me

Ry

Link to comment
https://www.sau.com.au/forums/topic/320783-r32-bits/
Share on other sites



  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...