Jump to content
SAU Community

Recommended Posts

just a quick question. how much oil pressure do get when driving. on idol i get about just under the 2 mark on the stock gauge. and when i'm under it it goes upto just under the 4 mark. is this bad or normal. i'm running castrol 25 - 50 i think can't remember.

that oil is very thick for a skyline!! should be running fully synthetic 5-40 or similar

25 - 50 is thicker that what i ran in my old torana...

your pressure is slightly higher than what i was getting on helix 0 - 40. atm i'm getting a max of 2 on the gauge with penzoil so i'm gonna change back to helix.

from what i have seen in the forums most gauges dont seem to get much over 1/2 way.

When i first got the car i was running helix and a ryco filter and only getting around 2. Spent the money on motul 10-40 and a sard filter and now get at least 4 all the time. Find higher pressure gives much better all round response. Anybody suggest something even better?

Hey all,

I run a Ryco filter with Shell Helix Ultra 5W-40 in my R32 'line and I find my oil pressure sits around 4 just about all the time.....When I first start the car it sits on 2 or so but the sender seems to be very slow to update (typical R32 skyline oil pressure sender!!) as sometimes it takes a while to rise to 4 after idling.

mine sits on around 6 in the morning, after warm up it will sits around 4, when going really hard it will up to 6 again.... pretty good and smooth driving...using motul 15w50. Is that normal? But at least i could tell is, i cannot see any problem and the car running alright!

cheers

steven

but your a 25:P

dont use helix ultra

its shit and makes ya pressures go like crap

use nissan oil filters and nissan oil

it seems the best for me so far

and cheapest

nissan make good cars

good motors

why would they sacrifice on shit oil ?

they wouldnt :)

ScarifieR, I read just recently on SAU that the Nissan oil is just some mineral based stuff they resell, so why would it be better then a fully synthetic oil like Shell Helix Ultra?

I'd say my 'lines oil pressure wierdness has more to do with a dodgy oil pressure sender then anything else.

nissans oil is a 50/50 mix

for rb's its good cause the blocks iron/alloy

use fully synth on sr's n stuff

i just found it to be the over all best

that helix was junk

went in and the pressures went low

and when i dumped it , it was all like detergent and bubbly once it hit the pan

there is penzoil in my car atm & i'm goin to drain it & go for something else as oil pressure it gave was less then helix, sometimes almost hitting the 0 stopper!

also, since the penzoil has been in i have a ticking lifter for around minute at start up.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
×
×
  • Create New...