Jump to content
SAU Community

Recommended Posts

I have a set of R32 GTR - Guard liners, Brake ducts, Undertray

They are in very good condition with the only fault being one of the brake ducts has a little section worn on the front edge.

These are getting very rare and hard to find in this condition. First thing to get damaged on gutters and accidents.

The last set I sold I recieved about 25 pm's and sold in a night so we'll see how long these last.

$200

The site won't let me upload atm so I'll put some pics up later.

Also I won't seperate the ducts so please don't waste yours and my time asking.

Melbourne

  • 2 weeks later...

Hey mate,

I'm super keen on the center piece of the tray (it's the only bit I'm missing on my car). I have money and can pick up any time you like (I'm in Melbourne too)

If there is another person on here who's only keen for the side bits + air ducts maybe we can do a clean separate?

Otherwise, if nobody wants the other pieces, I know separating parts is a pain in the ass so I wouldn't expect you to do it :(

Cheers,

Sean

Sean,I'm interested in the side ducts and guards, but I'm in Sydney.

How much would freight cost if possible? And how much would you want me to pay for the guards/ducting?

Let me know, regards, Luke.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...