Fs: Plenum Spacer, Panel Filter, Pod Filter

[Kam-80]

OK guess I should try and clean out the garage, as it's starting to get hard to park the car in there...

Pure Innovations Plenum spacer - $100

This is a flat spacer (not angled) for maximum airflow but won't clear the factory strut brace without spacers. I believe I have all the spacers, will confirm tonight. Supplied with plenum gasket, but advisable to get a new one from Nissan for 100% air-tight fit. Good improvement in mid-range with this mod.

Trust Airinx-GT high flow panel filter - $50

Used for only 1 track day and a few hundred k's before boosting the car. I chose the Trust because (apparently) the filter material is the best flowing. Breathes much better than stock.

Apex'i Pod filter and heat shield - $60

If you're after a pod filter, this flows quite well and the heat-shield helps with the heak-soak.

Will post up some pics tonight or tomorrow, PM me if you're interested.

[pv35gt8]

What size is the plenum spacer (how thick)?

[GTS-t VSPEC]

Interested in the Pod Filter, will you ship to Perth ?

[fcruz3r]

very keen on the spacer...does it come with the spacers/washers for each bolt and extended bolts for the plenum?? If it's the complete kit and all that's required is a new gasket...then please pm me shipping cost to perth and banking details for funds xfer.

cheers

ps: can I still use the factory engine cover without fouling on the bonnet??

[Kam-80]

  pv35gt8 said:

What size is the plenum spacer (how thick)?

10mm thick all round.

  GTS-t VSPEC said:

Interested in the Pod Filter, will you ship to Perth ?

Yep shipping to Perth is all good, around $10.

  fcruz3r said:

ps: can I still use the factory engine cover without fouling on the bonnet??

I'm not sure about the V35/G35 but I could still use the 350Z engine cover.

Plenum Spacer and Panel Filter on hold.

[GeNOS]

spacer still available?

[fcruz3r]

cool.

pm me shipping & payment details for the spacer. the longer bolts & washers are included yes?

[GTS-t VSPEC]

  Kam-80 said:

Yep shipping to Perth is all good, around $10.

Ok, PM me bank details

[Kam-80]

Fcruz3r; pics below...hmm I appear to be missing 3 of the small bolts when compared to the stock picture. But I've counted on my plenum and it only takes 9 bolts.

You can compare the inventory with the stock photo from Pure Innovations;

Edited August 25, 2010 by Kam-80

[R6n350GT]

Dam, im after pod and spacer.. ill buy both if still available

Edited August 25, 2010 by R6n350GT