Jump to content
SAU Community

Recommended Posts

z32s are 80mm and GTR afm's are 65mm

so they are larger and can physically measure more airflow

there is zero gain to fitting z32s other than being able to run more air through them

ie if your at 300awkw you wont gain power going to twin z32s

it will cost you a bomb however doing it

for GTR keep the 65mm shell and go for twin nismo afm's

these are 65mms and direct swap and it's a Z32 sensor inside the shell

so you get higher resolution in same shell and direct swap

yeah there is a changeover point where you peak 5v on the stock GTR afms and need to upgrade

the problem is it's a costly exercise so a lot of tuners have been able to strech the curve a bit

when you max them there is no harm done, it just means it cant show any more resolution

this means you dont use anymore load cells on the tune

if you max them at 6000rpm not a big deal

if you max them at 3200rpm a big deal and it ends up being a map sensor tune

when i say a map sensor tune, i mean the load axis never changes once you reach target boost

as map sensor is on pressure and boost is fixed by wastegate / boost controller

The modifications to the car are -5 turbos, tomie cams, power fc ,injectors,dumps ect.. the engine has just had a fresh build with forged internals.. i just want to get it all sorted before taking it in to be tuned.. what is your opinion? do them before it gets tuned?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Started sifting thru my brakes to decide which ones I will run on Clem   Made me think I should just put them all on Silver...for when brake fade just isn't an option   Should be able to bump rotor up from 343x32 to 348x36 off Supra. Not sure if the Supra annulus is right for the Alcons or APs but trying g to find a used Supra\M4 rotor to test fit The Alcons seem to gain 1-2mm clearance which all helps  
    • So car is getting a few mods to the cage and some jacking points welded in Meantime Ol Silver gets a new gearbox and shiny clutch.  Old Box is being set aside for Clem  
    • Probably speedometer itself if the odometer is ticking. If the needle is stuck from a bit of grease or something that can cause it to stay at 0. Or a cracked solder joint in the speedometer can do it too.
    • Thanks Fella’s   to take this off topic and to elaborate a bit more. I have an rb25/30 going into a r32 GTST.. expected to make around 600-700hp. Would you?   A) R34 GTT box   B) CD00#?  I’ve seen a few posts about the CD swap and sounds fairly involved with making it fit etc but if it’s worth the work then I’ll go that way
    • Lower at the hubs. Funny I forgot to mention that part. Do this pull here I turned the camera off too soon but the graph shows a drop at the top and that was because the pipe from the turbo blew off. The tuner said we could’ve made possibly another 15 whp. He also added if I switched to ethanol we could up the boost some more as well. I was comfortable capping it at the most of 20 pounds. Turns out the turbo pipe just needed a new worm clamp. Got home replaced that then did a third gear pull from 3k to 7200 rpm and the power was great to the top. I just got an ecu mounting bracket from IEE that I need to try and get everything to fit well. It’s a PITA to get the harness and ecu fit properly behind that kick plate 
×
×
  • Create New...