Jump to content
SAU Community

32 Gtr V-spec

yohoRB26
 Share

Recommended Posts

yohoRB26 Apprentice

yohoRB26

Posted
Posted

hi all, few months ago i purchaced a clean as r32 gtr v-spec 93 model. It came with 18 inch bbs wheels, usual brembos :rofl:, thicker strut braces, full exhaust from front pipe back, and awesome Aragosta coilovers :) :).

So far all iv done is replace the spark plugs, all bushes are new and compression check the motor which came up all really close, and remove the boost restrictor which suprisingly made a nice difference :) Next mod im getting is some dba motorsport slotted disks and project mu pads, then some front camber arms:)

At the moment im looking at getting a new frontpipe and some aftermarket split dump pipes while im in there. Was wondering if anyone knows of a brand of front pipe which sits relatively high under the chassis and doesnt cost a fortune?? Not after titanium as its way to $$$. The front pipe i have at the moment sits a bit on the illigal side and im not after anymore defects.

Im also chasing some nismo LMGT1, LMGT2, LMGT4 or BBS-lm wheels as id love to be running a set of any of these in 18x10 but they seem real difficult to come across a decent set in gtr size.

Also wondering if anyone knows what benifits if any are to be had by getting a stainless steel exhaust manifold on the standard turbos.

heres a pic to show which i dont wanna have to wind those coilovers up despite the exhaust being 7 cm of the ground :P

post-77046-1286944029_thumb.jpg

post-77046-1286944362_thumb.jpg

post-77046-1286944455_thumb.jpg

post-77046-1286944481_thumb.jpg

post-77046-1286944495_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/340286-32-gtr-v-spec/
Share on other sites
(OO)SKYLINE(OO) Grand Master

(OO)SKYLINE(OO)

Posted
Posted
At the moment im looking at getting a new frontpipe and some aftermarket split dump pipes while im in there. Was wondering if anyone knows of a brand of front pipe which sits relatively high under the chassis and doesnt cost a fortune?? Not after titanium as its way to $$$.

- http://www.skylinesaustralia.com/forums/JJ...=gtr+front+pipe

$299 for Front Pipes.

+ I think it is $30 postage..?

Im also chasing some nismo LMGT1, LMGT2, LMGT4 or BBS-lm wheels as id love to be running a set of any of these in 18x10 but they seem real difficult to come across a decent set in gtr size.

- http://www.skylinesaustralia.com/forums/Ne...to-t337147.html

Brand new Nismo LM GT4 in Bronze. 18 x 10.5" +15. $4400.

Not the exact size you want but Aaron has more wheels in stock.

Also wondering if anyone knows what benifits if any are to be had by getting a stainless steel exhaust manifold on the standard turbos.

No point in changing the exhaust manifold if you are running stock turbos.

Link to comment
https://www.sau.com.au/forums/topic/340286-32-gtr-v-spec/#findComment-5494678
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • CF.Panda
      R34 25GT Engine Light 21

      By CF.Panda · Posted

      I wasn’t able to replicate the sound anymore. It was a one time sound so maybe it was just coincidence but it was like small pebbles being dropped in a coke can.   should I try cleaning the MAF? It could be it’s functioning but dirty? I don’t know.
    • sunsetR33
      Unpeeling the Orange

      By sunsetR33 · Posted

      Update 4: Hi all. The car drives again! Haven't driven for long, only to store it in the garage again, but the test drive was successful. The coolant and oil leaks seem to be fixed for now. Temps on the engine were also very good, while moving I never even saw 80C water during the approx. 30 minute drive. Ate up all the coolant in the reservoir though so will have to fill that even more when I go to the car next time. One thing that pisses me off is that the RPM gauge is still f**ked, I even resoldered the board twice and used copper paste on the silly screws that are used as connections. Next time I take it out I'll take apart the board and fit new components, I'll see if I can get a replacement IC for it.  I have an appointment set for 22nd of September for the engine tune to 370hp. Alignment also still needs to be done. My hope is that I can get all the legal stuff over with by the end of this season. Anyone of you have advice regarding intercoolers? Currently there is an APEXI core fitted, one of those weird hybrid ones, 600x270x76. I don't think it's bad but it's not new and now I still have the chance to change it now to legally include it in the paperwork. Only issue is that the only options that would arrive in time are a HKS Type R intercooler or generic Ebay spec intercoolers comparable to a JustJap one. Ideally I'd order a Plazmaman but it takes over a month to receive which would mean making the car legal has to wait until next season. Would love to hear some input on this. Same story for my injectors, the previous owner was a nunce and put ID 1050x on the engine. They work but are obviously not ideal at "normal" power levels. But I don't see a reason to change them unless the tuner says it's necessary. I read online before buying a different exhaust that the top secret style rear diffusers won't fit due to the size of the rear resonators. My buddy and I made it work by slightly "adjusting the shape" of the mounting bracket and making some spacers out of 3d print for the mounting bolts. Fits like a charm. Just putting this here in case someone has this problem. Even the hefty HKS Silent Hi Power rear can fits without hitting anything.
    • Butters
      UniClutch

      By Butters · Posted

      Well they got my money but they are not getting my gearbox ! 
    • GTSBoy
      ECU sees many times the speed than speedo does (R34 swap)

      By GTSBoy · Posted

      It's needed for rolling idle up, and I think it is a decider on VCT also.
    • Kinkstaah
      ECU sees many times the speed than speedo does (R34 swap)

      By Kinkstaah · Posted

      I mean, not really. Link ECU's can absolutely still have errors from the ECU thinking it's getting a sensor it's not expecting. I would imagine the speed at the ECU level in Nistune does absolutely nothing anyway? I assume the ECU does not do any fancy TC stuff with regards to front+rear wheel speed or anything of that like anyway. Someone who uses Nistune may be more fluent in it. 
×
×
  • Create New...