Jump to content
SAU Community

Recommended Posts

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

    You're all going to hell!!

Not me

for I am the Alpha and the Omega

genuflect in obsequience before me and all shall be forgiven.

There is a place for you all in Heaven at my right hand

to guarantee this place in heaven please submit a tithe of no less than 25% of your gross annual income, all donations are tax deductable.

(N.B This is not a guarantee)

Cash donations payable to

God

c/o Heaven

PO Box 111

Southport

Not me

 

  for I am the Alpha and the Omega

 

  genuflect in obsequience before me and all shall be forgiven.

 

  There is a place for you all in Heaven at my right hand

 

to guarantee this place in heaven please submit a tithe of no less than 25% of your gross annual income, all donations are tax deductable.

 

 Cash donations payable to

 God

 c/o Heaven

 1/46 Smith Street

 Southport

 

:rant: U funni Nex

i just found out my gearbox needs a rebuild soon. not happy. the front bearings in the gearbox are on there way out. u can hear them rattle when its in neutral and the clutch isnt engaged. will hold up for a few more thou kms yet. but its still a hassle. has any1 else had to replace theres?? what were tha costs like??

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There are black hose clamps as well if you care. Plazmaman for example sells some: https://plazmaman.com/product/black-hose-clamps-premium-quality-stainless-breeze/
    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
×
×
  • Create New...