Jump to content
SAU Community

Recommended Posts

selling whole R32 GTR wreck

no part outs at this stage

because i have to put a price up i'll put ball figure of $10,000

any decent offer will be considered

details:

1st owner in Australia

never been in track or drag under my ownership

been using motul 300V CHRONO

pretty much stock GTR

done 100,000km

Fujitsubo legalise R catback

mines VX panel filter

retro fitted HID using Honda Accord Euro Projectors

headlight black housing

KAIXEN HID KIT

R33 GTR Rims

3.jpg

1.jpg

more pics added later when i get the car back

Edited by TerryL
If you part out, price for rims? (Umm are the tyres backwards?)

As stated not parting out anything ATM...

dontknow haha had to replace my other rims with the R33 ones before it got towed away

Interested in;

Front Bar

Front Guards

Please PM me

As above

in the event that you do part this out

Shotgun:

airbox with mines filter

retro fitted HID using Honda Accord Euro Projectors

headlight black housing & KAIXEN HID KIT

Passenger side kick panel

Plus few other things

pm me mobile number

Not that I have enough $$ to buy it whole, but is it listed as repairable write off/still rego-able?

Interested in bonnet & grille if you do part out.

at first the insurance told me its written off than they told me its repairable write off??

i checked on revs and its not reported as repairable write off or written off

if no decent offer comes by 26th nov

than ill part out the car

Edited by TerryL

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...