Jump to content
SAU Community

Recommended Posts

just sold my car and have a few parts doing nothing

brand new Nardi sport Classic steering wheel with red stitching $300

r32 N1 gtr headlights with hid kit $300 ( imported from japan didn't get to put on car)

R32 clear indicators $100

Blitz blowoff valve with pipe $60

General CT Bendix brake pads brand new (fronts only) $50

Yashio gear nob $70

yashio drift button $15

s14/R33 stock wheels with roadworthy tread $200

type M factory spoiler $30

T25 turbo $50

Apexi electronic temp guage with memory $50

R32 JDM fog lights $40

R32 boss kit $50

R32 coilpacks $40

8mm spacers $20

if u want pics call or pm

cheers chris

0401442261

Link to comment
https://www.sau.com.au/forums/topic/347884-r32-goodiess/
Share on other sites

still heaps for sale ppl

R32 clear front indicators $100

Blitz blowoff valve with pipe $60

General CT Bendix brake pads brand new (fronts only) $50

Yashio gear nob $70

yashio drift button $15

s14/R33 stock wheels with roadworthy tread $200

type M factory spoiler $30

T25 turbo $50

Apexi electronic temp guage with memory $50

R32 JDM fog lights $40

R32 coilpacks $40

8mm spacers $20

Edited by chris_32
Link to comment
https://www.sau.com.au/forums/topic/347884-r32-goodiess/#findComment-5603910
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...