Jump to content
SAU Community

R32 Gtr 89 ""

danny14
 Share

Recommended Posts

danny14 Mentor

danny14

Posted
Posted

just bought a 32 gtr 89 '' with lots of mods quality built from ice performance in melbourne

it has a 4 wd, 2wd switch on it now how does this work i need to diagnose my awd so see if it works !

how do i tell

torque gauge on dash stays at 0 needle does not move ?

where are fuses etc loacted ?

can someone please help me

cheers

Link to comment
https://www.sau.com.au/forums/topic/348128-r32-gtr-89/
Share on other sites
blind_elk Grand Master

blind_elk

Posted
Posted

There is loads of information on this forum as to how the AWD system operates. Do a search.

The gauge will sit on 0 in normal driving. Your search will reveal when the gauge will move off 0.

The 4/2 WD switch works by isolating the ATTESSA computer. Again, heaps of information on this forum - SEARCH.

Fuses are located in the bottom of the dash, by your right knee (which you would have found with a search!).

Link to comment
https://www.sau.com.au/forums/topic/348128-r32-gtr-89/#findComment-5601884
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Haggerty
      RB25DE NEO with Haltech ECU

      By Haggerty · Posted

      Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • brillo
      Leak from Tokico BM50 Brake Master Cylinder

      By brillo · Posted

      Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • MBS206
      Cas issue

      By MBS206 · Posted

      It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • nash47
      Cas issue

      By nash47 · Posted

      Yes sir am asking is there possible way from aem tuner from wiring pins 
    • MBS206
      Cas issue

      By MBS206 · Posted

      Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...