Jump to content
SAU Community

Recommended Posts

Hi

I am buying a rb20det to put in to my r32 but am unsure if the motor is running or not. the motor is on a crate and has a ecu. The guy im buying it off has bought off someone else to put in a vl but had to sell the car. So what im getting to is, is it possable to run the motor on the crate (obviousley mounted) before i put it in the car only to find out that the motor dosnt run??

Thanks

Only if the gearbox and starter are still connected and you can power up the ECU. Set up some sort of dummy fuel system and away you go......

Or you could just tell the guy you want a guarantee that there won't be problems when you go to start it, and if there are, he will return your money. Get it in writing. If he won't, then go buy one from a wrecker who will. Decent RB20's only go for like $1000

when i bought my half cut they fired it up for me all they did was set up a dummy fuel system and connected a battery and away they went make sure you also do a compression test aswell no point buying a engine that start just to find out later down the track the compression is stuffed. make sure it is even across the board. mine was 151 150 151 150 150 150. as long as it does not fluctuate to much you should be fine.

without the gearbox the starter has nothing to bolt to so its unable to crank the motor, no crank=no start.

half cuts are easy to start, engine and box only not so easy.

as Elite said get a written warranty agreement if you buy it from that seller

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It says 300ZX, does that make it an Aus delivered car? Funny how back in the day I just couldn't care less about Z32's and these days I am just in love with them. Back when Nissan was into pushing the envelope. 🤣
    • Hi guys, just after some guidance with an R34 sunroof that has stopped working correctly. It still opens and closes perfectly fine, but it no longer tilts/vents up or down. As a result, the rear of the glass now sags a bit as it drops down slightly in order to retract into the roof, but now it can't pop upwards into a flush position. I’ve probed the pins on the back of the switch connector with a multimeter and it seems like both switches (for open/close and tilt/vent) still work correctly. Any ideas on what it could be, or where I should even start in terms of diagnosing? I'm sure someone's had this issue before but I haven't been able to find anything online relating to this specific issue, most of the issues are with the seals leaking or the motor failing entirely. Thanks in advance!
    • Do you have some data like fuel pressure? It's really hard to say if you're still fighting a fuel system issue at this point. Could be something weird like the FPCM dipping out.
    • Yeah in that case, pulling the dent out. Event a very slight dent can create a lot of work filler-wise and there is a strong chance the panel won't be the factory shape when you are done (as the dent will result in a new high point created somewhere, then everything is brought up to that new high point... but the panel shouldn't be that high if that makes sense).  So you've filled and primed the panel and it is flat, why would you go back and remove the primer and add more filler? 
×
×
  • Create New...