Jump to content
SAU Community

Recommended Posts

Hey all, i recently put an rb25 in my 32, after stuffing around with the wiring i gave up and bought a microtech lt12s with handcontroller and wired it all up, the previous owner was making 350kw off the tune thats on it but had bigger inj, ect, first start it ran rough as and blew a butt load of black smoke, the overall fuel trim was set at -25, i raised it till it idled smoothly ending up at +35%, after i had it running fine i drove it home (did the work at a mates house because he had a shed) when i got home i scrolled threw the controller and saw that the Timing Lock was set to on, i remember reading the microtech site and it said DO NOT REV THE ENGINE WHILE TIMING LOCK IS ON, so now im worried have i done damage??? when i drove it home i babied it, had it set to 6psi and didnt go past 6k revs, as i defently need a tune. Also, anyone know any good microtech tuners in qld? cheers.

Edited by 51NNA

Timing lock should only be used to set base timing. Turn it off.

It doesnt sound right because u would be driving around with 15degrees of timing. Would be really lazy down low.

Shouldnt have done any damage.

Turn it off and get a tune

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
    • yeh they are 235/45/17 up front and 255/40/17 in the rears. I still didn't get my answer if i can fit a 18x9 up front. I want to get 4 of this and see if they will fit before committing as they didn't see an 18x8 as an option but there is a 18x9.5 also.   Enkei RS05-RR 18x9 35mm ET 5x114.3 75.0 Bore Matte Gunmetal Wheel
×
×
  • Create New...