Jump to content
SAU Community

Recommended Posts

hey guys i have what i believe to be a 1.5 series r33 with a rb25det in it

i fitted a rebuilt and hiflowed stock rb25det turbo to it after i did that the stock boost raised from 7psi to 9 psi i had no issues was running fine.

the other day i fitted a turbosmart boost tee into the equasion so i could raise the boost to about 12 psi once i had fitted my fmic

i fitted the boost tee having alot of trouble then realised that i had to take the ball and spring out of it to allow it to run on my engine.

now my issue is that once i raise the boost to about 12psi under wide open throttle it misses and feels like it is fuel cutting like it completely shuts down the engine for a millissecond and comes back on but only half throttle it boosts fine. when i turn the tap fully closed then open it about a half a turn it runs the stock 9psi and drives fine

i have replaced the plugs the day i fitted the boost tee

any help would be fantastic please help ahahah :D

Edited by johnny boii
Link to comment
https://www.sau.com.au/forums/topic/363577-rb25det-missing-underload/
Share on other sites

it'll help but its not ideal and you certainly wont be able to get the most out of the highflow. a full aftermarket computer and possibly z32 afm and injectors, depending on power goals and the ecu, is the best solution.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • And I just realised that that advice is slightly nonsensical for a GTR, because you need 2 of them. But it is otherwise true.
    • Having had a reasonable look at the car, I'll be able to remove the (one time) rams and retract the hinge (they are held in the down location by a tiny (m3?) sacrificial screw) which will get it physically back in shape. From there if you remove the rams you need a resistor to turn off the airbag light (as Mark said, there are plug in kits and I might go that way because its reversible). And...per all the threads on here, even if you have the resistors to turn off the airbag light, the bonnet light will stay on as it writes to the airbag computer history - that is either replace the airbag controller, reprogam the EPROM (if I can work out how), or remove the globe from the dash. Having seen how sensitive this system is, if I had my time over I'd pre-emptively remove the rams, even on a road car, because this is all a very unnecessary pain in the arse. Reminds me, time to go and have a look at the Fuga too....
    • Hi, I need same this wing nismo , Does anyone have one for sale?  if any one have can contact me  00966546888343
    • Nah, lots of insurance repairs on V36 and V37 for pedestrians deployments. Reasons ranging from possums, to extremely severe potholes have deployed them. However, paying for the full repair can still be upto $5k AU some people have noted!
    • Hi, i got 1998 r34 4 door auto abs model and its manual converted with bigbox when i bought it . I successfully find the neutral and reverse light wire but can’t find the speed signal wires for speedo drive. I know its grey plug but on my loom no grey plug with 2 wires . I opened the loom upto where it getting branch with other wire, i’m amazed they is no wire. So need help how to fix the speedometer problem. I search on google it says some r34 model measure speed from diff sensor. Is it right? I talk to a wrecker he say no this isn’t right, i’m kinda stuck. Please help
×
×
  • Create New...