Jump to content
SAU Community

Recommended Posts

Well it might cause quite a few of you a lot of pain to know that I am considering moving on from my R32... I know, I know I'd be an idiot to sell it and all that, but this is only an Expression Of Interest because I have been thinking about this for at least a year now and my mind still isnt made up, so I need your opinions.

I am thinking of parting with my 1992 R32 GTS-T for somewhere around $13,000 (which I think is very reasonable).

Here is a "short" list of specs:

1992 R32 GTS-T M-Spec

Spark Silver metallic with custom vinyl graphics.

Engine:

- 1993 R33 S1 RB25DET conversion.

- Genuine Garret GT30/76R turbo with custom internal wastegate.

- Custom polished alloy intake piping, turbosmart triple ply silicone joiners.

- Z33 Air-flow meter + compact air pod (breathes plenty of air).

- JJR Adjustable exhaust cam gear.

- Custom front-mount intercooler 600x300x76mm with custom stainless piping, triple ply silicone joiners ad T-clamps.

- Turbosmart SS blow-off valve

- Genuine Splitfire coil packs + NGK spark plugs (gapped to 0.8mm).

- JJR oil catch can + breather.

- 45mm Alloy radiator with A'Pexi 3BAR cap and Davies Craig high temp hoses.

- Engine fan removed, Cooltemp 14" thermo fan installed with shroud and electronic fan controller (never gets above 90 degrees).

- Genuine TRUST Power Extreme II exhaust system (3" mandrel), TRUST front pipe and split dump pipe.

Electronics:

- A'Pexi PowerFC ECU.

- Turbosmart E-Boost street.

- Brant alarm (needs replacing).

Driveline:

- R33 GTS-T gearbox.

- TOMEI billet short shift kit.

- Exedy Hyper-single ceramic button clutch kit.

- Custom single piece tailshaft with Z33 uni-joints.

- Standard diff with 140W motosport oil for more lock (doesnt whine or clunk).

Brakes:

- Standard rotors, wheel bearings replaced under 20,000kms ago.

- Overhauled standard calipers with Bendix ultimate pads (I also have EBC Greens still in the box).

- Braided brake lines (ADR approved).

- Motul RBF600 brake fluid.

- Overhauled master cylinder.

Suspension & steering:

- TEIN Super-street adjustable coil-overs.

- Billet alloy adjustable caster rods.

- Genuine Nismo front strut brace.

- HICAS removed and locked (entire system removed), new rear rack ends and knuckles installed.

- Front steering rack overhauled, new boots, rack ends and tie rods.

Wheels & tyres:

- Volk Challenge 17x7 and 17x8 (don't know offset on these *very light-weight*.

- Federal 595RS tyres (about 50% tread) slightly over sized 225/45R17 and 255/40R17.

Interior:

- Stock standard seats, carpet etc.

- Isotta MegII genuine leather steering wheel.

- RAZO gear knob.

- Autometer boost guage in pod.

- PowerFC hand controller and E-Boost street unit mounted neatly on dash (no holes drilled).

Sound system:

- Alpine head unit (about 5 years old)

- FUSION 600W 4way amp powering FUSION speakers (very good sound but no fully sick sub-woofer).

Body:

- Genuine GTR V-Spec front bar (genuine Nissan).

- M-Spec side skirts and rear pods.

- Rear bar is slightly damaged from scraping on a car trailer but I plan to have it resprayed.

- Custom Nismo stripes.

- No accident history or dodgy repairs.

This car has been lovingly looked after, always garaged and serviced with Motul fluids every 5,000kms. I have done almost all of the work myself (so I know it's done right) any of the work that I have had done at workshops has been done by either Trojan Motorsport or ESP Racing.

Glenn at ESP tuned this car in this set up to 275rwkw (370rwhp) and over 500nm of torque at only 14.4psi but when not driven hard it is very comfortable and easy to drive on the street.

Pictures attached.

What I am asking is whether I should sell this car and upgrade (keeping the next car a secret at this stage) and is the price right?

NOTE: I will be putting a year's rego on it and can assist the purchaser in getting it passed over inspection.

Cheers,

Mick

post-17958-0-20553300-1305859424_thumb.jpg

post-17958-0-96105500-1305859441_thumb.jpg

post-17958-0-47178100-1305859852_thumb.jpg

post-17958-0-67465000-1305859876_thumb.jpg

post-17958-0-18934400-1305859890_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/364939-bullet32-eoi/
Share on other sites

  • Replies 66
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

hey mate,

i can see that its had a bit of work , but it's still a 32.

maybe around $5000???

Thanks Jester,

I realise that R32's are going cheap these days but there's no way I can go that low.

Thanks for your feedback though :)

Link to comment
https://www.sau.com.au/forums/topic/364939-bullet32-eoi/#findComment-5822595
Share on other sites

Wow what a deuche!

Mick that's such a nice car, I was actually thinking about it just the other day, such a nice power curve strapped to a rock solid 32!

It must be a hard choice to let her go.

So good luck! And by that I mean bad luck, so you get to keep it :D

Link to comment
https://www.sau.com.au/forums/topic/364939-bullet32-eoi/#findComment-5822713
Share on other sites

Wow what a deuche!

Mick that's such a nice car, I was actually thinking about it just the other day, such a nice power curve strapped to a rock solid 32!

It must be a hard choice to let her go.

So good luck! And by that I mean bad luck, so you get to keep it :D

Thanks Pat,

I'm having serious trouble deciding what to do... I love it and want to keep it but something else has come up and I want it as well... Decisions, decisions.

Cheers mate :)

Link to comment
https://www.sau.com.au/forums/topic/364939-bullet32-eoi/#findComment-5822725
Share on other sites

Hey Mick, that looks like one kickass 32.

if i hadn't already bought my 34 a few months back i would probably try to convince you to sell to me...

I'd be all over it for $12k - $13k.

I think you should keep it :D

Link to comment
https://www.sau.com.au/forums/topic/364939-bullet32-eoi/#findComment-5822774
Share on other sites

Scam a poor old lady - you can have both!

Hah! - Good idea, now to find a gulible rich old lady :)

Hey Mick, that looks like one kickass 32.

if i hadn't already bought my 34 a few months back i would probably try to convince you to sell to me...

I'd be all over it for $12k - $13k.

I think you should keep it :D

Thanks man,

I would only sell to a proper enthusiast like yourself who would really appreciate it. :D

Link to comment
https://www.sau.com.au/forums/topic/364939-bullet32-eoi/#findComment-5822787
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • Thank you so much for the help
×
×
  • Create New...