Jump to content
SAU Community

996 Porsche Cup Car Brembos

Daz
 Share

Recommended Posts

Daz Grand Master

Daz

Posted
Posted

post-3332-0-69250600-1308368684_thumb.jpgpost-3332-0-69250600-1308368684_thumb.jpgFor sale is a brand new set of Porsche 996 Cup Car Brembo 6 spot calipers and Brembo 355mm x 35mm rotors.

I will also throw in new pads.

The calipers are brand new and have ceramic pistons, these are massive calipers and will need a minimum 18" wheel

Brembo rotors are about 25-30% worn.

All you need to do is get custom hats and brackets made up.

Price $2,600 ono

Would prefer a Melb buyer

Thanks

Darren

post-3332-0-38647200-1308368694_thumb.jpg

post-3332-0-92069000-1308368753_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/368151-996-porsche-cup-car-brembos/
Share on other sites
  • 2 weeks later...
  • 2 weeks later...
luke gtr Grand Master

luke gtr

Posted
Posted

Are these the ones that are backwards or something?

by the look of it, they are set up to run towards the rear of the wheel, rather than in front as per the standard skyline caliper.

the larger piston should be in the dirrection the rotor rotates(rotor going clockwise, should be last piston past by the rotor).

so if mounted as currently set up, the piston will be on the wrong end.

you should be able to swap the bleed nipples, and transfer pipe(possibly have to get one made up), and youll be fine. :thumbsup:

personally, if i had the cash, id snap these up, hot looking calipers, with pads and rotors...

just saving the dollars as we type.

good luck with sale, will be an awesome addition to someones car.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Anyone running the VQ37VHR with forced induction?

      By GTSBoy · Posted

      Wrong question. There's no point in spending the rather large sum of cash and effort to add turbo, without taking it to the "sensible" limit of the motor itself. If you have to upgrade injectors, etc, then so be it. That is a tiny fraction of what it will cost you to turbo it.
    • GTSBoy
      Starter motor replacment teeth count.

      By GTSBoy · Posted

      Measure voltage at the starter solenoid terminal when the key is at start and it has clicked. If it is really low, then the suspicion falls on the ignition switch (contacts or wiring thereof) as causing a voltage drop instead of sending enough volts to throw the solenoid all the way to engage the starter itself. If it is a decent voltage, then the suspicion is on the solenoid. Might have s horted coil, or might hva dirty contacts. Rip the starter off, dismantle, clean up contacts and inspect winding. It might not be possible to see if there is a short in the winding though. I have a spare starter here that I could measure the resistance of the coil, as a guide to about what it should be, if you need a comparison. <parts hoarder>No you cannot have it.</parts hoarder>
    • oHBoy.
      Starter motor replacment teeth count.

      By oHBoy. · Posted

      lights are on just the one click.  
    • GTSBoy
      Mistakes were made, my R34 Story

      By GTSBoy · Posted

      Absolutely matters because, while a temperature change will eventually reach a sensor at the end of a static line, the response time is far far far too slow to be useful. Might as well not have a temp gauge at all.
    • f00stx
      Anyone running the VQ37VHR with forced induction?

      By f00stx · Posted

      When I was eyeing off the 370GT (after deciding I didn't want to spend 30-40k+ to relive my early 20s in an R33) I thought it'd be a good project to add a turbo to it. Now that I have a 370GT, and I've had a couple of chances to open it up, I'm pretty stunned by how much power it makes 🫠 Honestly, the way the VVEL opens it up, it almost feels like there's a little turbo tucked away in there somewhere. It's like Nissan looked at VTEC and said "hold my beer" 😁 Has anyone thrown a turbo into their 370Z or 370GT? Is there a conservative boost level you can run without having to upgrade the fuel system, or are bigger injectors and a bigger pump a given?
×
×
  • Create New...