Jump to content
SAU Community

How Does Your Tcs Switch Work?

mattcooper
 Share

Recommended Posts

mattcooper Apprentice

mattcooper

Posted
Posted (edited)

Hey Everyone!

Recently acquiring my R34 GTT I was told that the only known problem with the car was the TCS switch doesn't work. I was advised if I want to turn TCS off I would have to unplug a certain wire from under the bonnet.

IMG_0015.jpg

So my question is does the switch suppose to click into the opposite position? Because if I press it, it doesn't stay in that position. If this is normal does anyone have ideas on why the TCS wouldn't be working correctly? Do the switches normally fail or is this something to do with the BCM.

Thanks

Regards

Matt

Edited by mattcooper
Link to comment
https://www.sau.com.au/forums/topic/368209-how-does-your-tcs-switch-work/
Share on other sites
  • 2 years later...
suwidji Experienced

suwidji

Posted
Posted

Sorry to bring this back up again, but I have the same thing happening to mine.

However, i don't even have a TCS icon lighting up in my dash, as I've read around there should be one?

Any way to diagnose, and if my traction control is actually on/off/working?

34GeeTeeTee Grand Master

34GeeTeeTee

Posted
Posted

Sorry to bring this back up again, but I have the same thing happening to mine.

However, i don't even have a TCS icon lighting up in my dash, as I've read around there should be one?

Any way to diagnose, and if my traction control is actually on/off/working?

Do a skid :P

I had/have a traction control reverse circuit in the car, so automatically it is reversed and switched off when you start the car! Its still in the car but i dont have traction control any more since i went FFP! The traction control just slows you down!

suwidji Experienced

suwidji

Posted
Posted

I was actually attempting to burnout last night to test it, but the car just stalled abruptly when i popped the clutch. But I also wasn't sure how to tell if the traction control was on or not. Is that a sign that it was still on?

lol, also what is FFP? :rolleyes:

34GeeTeeTee Grand Master

34GeeTeeTee

Posted
Posted

I was actually attempting to burnout last night to test it, but the car just stalled abruptly when i popped the clutch. But I also wasn't sure how to tell if the traction control was on or not. Is that a sign that it was still on?

lol, also what is FFP? :rolleyes:

No that is a sign you are doing it wrong :P

FFP = Forward Facing Plenum!

darksky34 Mentor

darksky34

Posted
Posted

just check the bulb first, and test by turning on the ACC. swap it out with an existing bulb you know that works. having said that when i press my switch no light comes on, never did (well im not the first owner in AUS anyway) - but my friends told me that a lot of jap cars have TCS unplugged

34GeeTeeTee Grand Master

34GeeTeeTee

Posted
Posted

just check the bulb first, and test by turning on the ACC. swap it out with an existing bulb you know that works. having said that when i press my switch no light comes on, never did (well im not the first owner in AUS anyway) - but my friends told me that a lot of jap cars have TCS unplugged

TCS is usless :P Unless you are a useless driver in which case it may save your life haha

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • dbm7
      R34 Skyline climate control unit transistor

      By dbm7 · Posted

      That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
    • bilbo117
      R34 GTR Seats / No longer reclining

      By bilbo117 · Posted

      Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • joshuaho96
      Ethanol Content Sensor - Always at 11%?

      By joshuaho96 · Posted

      The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • GTSBoy
      R34 Skyline climate control unit transistor

      By GTSBoy · Posted

      It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • GTSBoy
      Blue slip

      By GTSBoy · Posted

      South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
×
×
  • Create New...