Jump to content
SAU Community

Recommended Posts

So about every 8-10th time I start the GTR, the 4wd light comes on about 5 seconds later. If I turn off and start again, it goes off and stays off.

Will be taking to mechanic for a service + brakes replace/check and this as well, wondering if SAU knows what it could be :) I'm guessing perhaps due to cold (where I am is pretty cold, and often I don't start the car for a couple days), or perhaps low fluid, or some electrical relay.

Link to comment
https://www.sau.com.au/forums/topic/368942-r32gtr-4wd-light-intermitent/
Share on other sites

When you do have the light lit, leave the ingition on and open the boot. Look on the underside of the parcel shelf and the left hand module has a led indicator in a see-through port on the bottom. Count off the flashing sequence and look in the manual for the fault code relevant.

Leave the sub there and take the control module out? What more do you want? At least it has a fault light so you can do some diagnosis, rather than guessing..

Serious though, maybe an inspection mirror will let you see it, unless you have enclosed the lot.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Kittens in first to claim dominance of the residence, then puppies later From past experience, the other way around can be problematic to say the least  Those weird "Dobby looking"  little kittens are not cheap....LOL
    • At least yours have parkour down pat. One of mine will still trip over his own shadow and fall over... He's a special type of cat... Ha ha ha
    • The question then becomes - was there any fluid coming from that hole before you did the rebuild ?    You may not have noticed, of course.   Depending on how you did the rebuild, the possibility has to be considered that somehow (cleaning ?)  fluid entered that hole and is now being 'forced'  out by small movements of the proportioning valve.   From the factory, there's actually a small rubber plug in that hole but with age and under-bonnet heat it's quite common for it to 'go missing'.  That rubber plug is designed to allow the venting process but also to prevent 'stuff' getting to the area (prevent corrosion, etc).   The plug is also not available as a spare part AFAIA. Personally I wouldn't race and buy a new master just yet but keep an eye on the area to see if the 'leak' continues.   If you're concerned about brake fluid damaging nearby paintwork, cable tie a piece of suitable absorbant material over the hole and remove/monitor occasionally.    Operation of the proportioning valve and the brake master itself won't be affected, but also keep an eye on brake fluid level, of course. In terms of a new master, the genuine part is getting expensive, unfortunately.  Amayama is showing AUD900+.   I was searching recently and there's an aftermarket part available from Japan made by 'Parts Assist': https://zenmarket.jp/en/yahoo.aspx?q=BNR32%2bBM50&p=1 Whether it's any good I have no idea, although in my experience Japanese aftermarket stuff is pretty good quality-wise.   The above site allows overseas buyers to purchase stuff more easily from Japan but there are fees and shipping costs, of course.   The original Japanese seller page is here: https://auctions.yahoo.co.jp/jp/auction/p1197401228 Copper/Nickel is fine but I still prefer bundy tube and it's also cheaper.
    • Your chihuahuas look weird!
×
×
  • Create New...