Jump to content
SAU Community

Recommended Posts

Have a small issue where the car just cuts out/dies usualy when stoped or ideling, not like a stall more like is just shut off, then the VDC Slip and SES (engine light) come at next start. When I go to start next it take longer to turn over, about 3 times as long. (this is the second time this has happened). After first instence i hit the web and Found similar stories on g35driver and such, people having the same issues are saying it is the "Cam position sensor" so naturally i assumed it was the same thing even found part numbers for both bank1 and bank2 sensors... but today I notice that this hose was not on all the way it had come lose as I had not put the clamp back on correctly when I installed my new Cat Converters about 4 weeks ago :/ *kicks self*

So I am lil bit concerned as i have no idea how long this hose has been detacted.Is it really bad if i drove with this hose disconected? pic below

IMG_0973.jpg

Any andvice would be great

thanks in advance guys.

Link to comment
https://www.sau.com.au/forums/topic/375360-help/
Share on other sites

Eeeeep that unattached hose means the engine is sucking unfiltered air into the engine which could contain dirt particles. Get that shit back on ASAP!!!!!

Although i have seen other people and heard of other people opening their bonnet and finding this hose not attached and there was no problem at all. Its just luck if it sucks in a lil rock and blows the engine (worst case scenario)

Link to comment
https://www.sau.com.au/forums/topic/375360-help/#findComment-5987576
Share on other sites

Eeeeep that unattached hose means the engine is sucking unfiltered air into the engine which could contain dirt particles. Get that shit back on ASAP!!!!!

Although i have seen other people and heard of other people opening their bonnet and finding this hose not attached and there was no problem at all. Its just luck if it sucks in a lil rock and blows the engine (worst case scenario)

cool thanks for the heads up, hose is bak on it looked clean inside guessing wasn't off for

that long however the hose is back and still the car suhtting off problem remains happen again just now I leaning more toward the cam position sensor now can any one tell me where is the best place to take the v in Brisbane to have some one read the error so I know witch bank it would be ?

Link to comment
https://www.sau.com.au/forums/topic/375360-help/#findComment-5987593
Share on other sites

Is your car hard to start sometimes??

My car use to randomly stall now and again then a week or 2 later it was hard to start (kept cranking but didn't fire up. Unplugged the sensor then cranked it, it would start up but took a lil longer then usual) when my Cam Position Sensors where stuffed.

Link to comment
https://www.sau.com.au/forums/topic/375360-help/#findComment-5987849
Share on other sites

Is your car hard to start sometimes??

My car use to randomly stall now and again then a week or 2 later it was hard to start (kept cranking but didn't fire up. Unplugged the sensor then cranked it, it would start up but took a lil longer then usual) when my Cam Position Sensors where stuffed.

witch sensor did you replace ? Or did u replace both and would they be the same as the 350z, cus nissan want 340ish for both

Link to comment
https://www.sau.com.au/forums/topic/375360-help/#findComment-5988570
Share on other sites

witch sensor did you replace ? Or did u replace both and would they be the same as the 350z, cus nissan want 340ish for both

Drivers side sensor was stuffed, i just replaced both so i didnt have to replace the other one later on.

Yes, they're the same as 350z, and $340 is about right from nissan.

Link to comment
https://www.sau.com.au/forums/topic/375360-help/#findComment-5988818
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...