Jump to content
SAU Community

Recommended Posts

Picked up this wreck few days ago.... it's a 1995 non V-spec R33 Gtr. Front end is smashed so front bar, lights, intercooler etc are not available. It's also had a hit on the passenger side. The engine is good so if it doesn't sell i'll keep it as a spare for my race car.

IMG_1278.jpg

IMG_1277.jpg

Parts can be picked up from Valley Heights Sydney or I can ship almost anything at cost.

Check in at the last page of the thread regularly as I'll keep updating what's left, I'll post pics up over the next few days.

Rb26dett engine $3,900

Runs well with good even compression. Complete engine including wiring loom, ECU, turbos, intake and exhaust, injectors, coil packs etc.

R33 Gtr gearbox $800

Non V spec diff $400

Driveshafts $150 each

Hubs $400

Front and rear cradles $150 each

Lower control arms, front $120

Fuel tank $100

Stock R33 Gtr exhaust $250

Stock R33 Gtr suspension $300

Attessa pumps $150

ABS unit $200

Stock air box $200

Has one chipped clip

Intercooler piping $200

Stock BOVs $140

Brake master and booster $100

Pair of R33 Gtr rims $550 (the other two are badly damaged and will go to the scrap yard unless someone wants to make an offer. Been quoted at least $175 per rim to repair).

Brembo brakes $1,500 front and rear or $1,200 fronts and $300 rear

Includes rotors, calipers, lines and pads with plenty of meat.

Front stock strut brace $100

Rear stock strut brace $60

Boot lid with wing $400

Rear bar $250

Tail lights $130 pair

Front bar lights $50 pair

Drivers side front guard $100

Includes Gt badge, good condition apart from a small amount of damage near indicator (see pic)

Inner guard liners with factory air guides $150

-A couple of cracks which do not affect the fit to the car at all.

Front guard GT badge $10

Drivers side door $150

Good condition, does not include interior trims

Drivers Door trim $100 (no window switch)

Passenger side door trim fabric (handy if you want to replace your damaged fabric) $20

Window switch $50 drivers side, $40 passenger side

A pillar trims $50 each

Full set of R33 Gtr floor mats $230

Excellent condition, no holes or cigarette burns. Just need a quick clean.

Centre console $60

Includes Gtr badge. One of the mounting screws is broken however this cannot be seen when the lining is placed inside.

Console stereo surround $30

Gauge cluster with 64,000km $230

Climate control unit $40

Triple gauge cluster $60

Stock stereo $40

Stock steering wheel $150

Air bag is deployed but otherwise good condition (just swap in your good airbag)

Dash pad $100

Rear vision mirror $20

Sun visors $10 each

Rear seats $330

Seat belts $40 each

B/C pillar trims $50 each

Rear trims $70 driver's side (perfect condition) $40 passenger side (has some minor damage)

Complete boot interior $150

Space saver $70

Rear window $200 (Pick up only, you remove or pay for the window dude to remove it)

Set of wipers $50

Wiper motors $50

Everything is for sale, if you need something just ask. I'm also wrecking an R33 gtst so it would help to specify in Pms whether its for Gtr or Gtst!

  • Replies 143
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Are the rocker covers, timing belt cover & coil pack cover available separate to the engine? if so please PM me a price?

Edited by 18RZZ

How much for the front seats?

passenger seat is bent good for fabric and parts $150

driver seat jenna has already flogged and stuck in her gtr

30 bux delivered

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...