Jump to content
SAU Community

Recommended Posts

Do you love the look of copy rims, but just arent baller enough to by chinese?

Enjoy having 1968 Cabernet Sauvignon but siphon it into a goon bag to not look too fancy?

Do you wish people kept saying "Nice drift teks" just after they said to your mate with TE's "nice rota grids"

Then buy these rims .......

They are genuine URAS NS-01's

They are what the TE37 is to the Rota Grid.... but to the drift tek

Pretty much look boss on anything with 5 studs and not gay (so no subie, honda, modern yota)

Set of 4, thats right, one of the few sets of rims that I own im thinking of letting go of

Bought these babies for a substantual amount of cash, you know in a time where people didn't blink at spending close to 2k on rims. Was about 3 years ago, about a month or 2 after I bought my 14 and have been on it in some way most of the time I've owned it.

As the 14 is track only I dont really need 5-6 pairs of skidders no need to clear the garage a bit.

They are in suprisingly good condition.

all rims have very light scratches on face

they all have very light rash on the lips from rocking streach the whole time

one has about a 10cm deep rash from clipping a gutter while parking

the are the holy size

17in in diamiter..... Cheap tyres from semis to chinas it easy to find something

9.5in all round..... Not to wide to run into inner clearance issues, but fat enough

+15 Offset all round..... Fill out near any stock gaurd

Not quite silver, not quite alloy.... just awesome

So once again thats 17x9.5+15 all round

They will look boss on any S or R chassis with just strech and a gaurd roll, no flare needed

They love strech and can take a 215 all day everyday

What am I asking for these lovley scamps

$1100 Rims alone

$1500 Rims + 70% 215 KU36 semi slicks and brand new cheapie 215s

$1800 as above with a spare pair of Work Equips 17x9+20 for skidders

mil2fm.jpg

IMG_3278.jpg

2dj14j5.jpg

1eti7m.jpg

Link to comment
https://www.sau.com.au/forums/topic/395930-17x9515-uras-ns-01/
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...