Jump to content
SAU Community

Recommended Posts

33 gtst - clutch and full exhaust (bellmouth)

Had issues for a while when I fill up tank with fuel and start the car it won't idle correctly and hunts (sometimes stalls)

This issue I was always a bit whatever about it. Hit the throttle and she settles ok.

Major concern is:

I have had a very intermittent issue where the exhaust will pop when I decelerate with no throttle and then touch the throttle it will pop no matter how many times I go on an off throttle. Sometimes it will get so bad it will pop whilst decelerating down revs without touching the throttle.

Through the revs doesn't miss a beat.

Did it with 2 different motors in it. (blew motor) Only things that remained on change of engine was afm, tps, coils and loom. (fuel pump of course)

Cas, plugs, fpr, injectors all changed.

I got consult to find O2 sensor sitting at .3 when cold then when at temp sits around .1-.2V. Had a spare sitting around so tried that and it just read 0.0-0.15V. So I Bought O2 sensor and found readings Fluctuated from .28-.80V. Which a mates car also did. Got better fuel consumption of course.

Car still popped intermittently.

Tested for vac leak and all good.

Tested tps voltage and all good.

Also I originally had exhaust studs snapped so gathered that would cause popping. Changed all studs and gasket. Still popped intermittently.

It was very intermittent so hard to diagnose but of course now I am in QLD on holidays it is doing it a lot more then normal.

I have found that when I'm low on fuel it doesn't pop at all no matter how much I cruise or thrash it. I pull into servo and put fuel in and I pull out to check if it pops and it does.

So I am thinking fuel pump but why or can u guys think of something else?

Sorry for massive read but wanted to give as much info as possible.

I also understand if u all are not in the mood to think as it is Easter and u may be drunk or hungover.

Link to comment
https://www.sau.com.au/forums/topic/397196-exhaust-popping-on-decel-bad/
Share on other sites

Also check tps setting.

Did u keep the charcoal canister or remove it? If u removed it wat did u do with the lines? I had a mate route his breather line to the inlet manifold and wondered why it was running rich on decel and accell

Stock bov not blocked.

Exhaust wrap isn't needed for flames lol. It's stock and people think its off tap cause it blows flames.

Charcoal canister lines were put on as they were but will gO over them in the morning.

Checked it couple times as that's what everyone thought it would be and didn't believe I checked it right. It is set at .43v and reads normal on consult when issue is happening.

I'm going to get stuck into it now and see how I go.

One way to check whether or not its the TPS is to turn the ignition off whilst on decel and see if it makes any difference. If everythings working as it should it shouldn't make any difference. Just make sure the motors hot first

Yea that's still the same with ignition off.

I have vented charcoal canister to Atmosphere and it hasn't popped and carried on today.

Will hook canister back up tonight and see if it pops (of it does) then i will undo it to see if it fixs it.

Also found fuel filler fitting loose which is why fuel leaked last DECA.

Just did manifold gasket as I had 8 snapped studs lol. All new genuine parts. Reused gasket to exhaust which was fine.

When it was popping I thought this was due to fix it for sure but didn't :(

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
    • Forgot to include this but this is the mid section of my steering rack that looks like it has a thread/can be turned with that notch mentioned in the post:
    • Hey everyone, Wanted to pick some brains about this issue I'm having with rebuilding my 33 rack (PN is 49001-19U05). All of the tutorials/videos I've seen online are either R34 or S Chassis racks which seem to be pretty straightforward to disassemble but this process doesnt carry over to my rack. Few of the key differences that I've noted The pinion shaft on the other racks bolt on with 3 torx bolts: Whereas my rack bolts on with 2 allen head bolts: These changes are pretty inconsequential but the main difference is how you pull the actual rack out of the housing. The other skyline/s chassis racks can be taken out by tapping the rack out of the body with a socket and it just slides right out. I'm unable to do that with my rack because there's a hard stop at the end that doesn't let the seal/shaft be tapped out. Can also see a difference in the other end of the rack where mine has a notch that looks like you're able to use a big wrench to unthread 2 halves of the rack whereas the other racks are just kinda set in with a punch. My rack: Other racks: TLDR; Wanted to know if anyone has rebuilt this specific model of steering rack for the R33 and if there were any steps to getting it done easier or if I should just give this to a professional to get done. Sorry if this post is a bit messy, first one I've done.
    • I would just put EBC back on the "I would not use their stuff" pile and move on.
×
×
  • Create New...