Jump to content
SAU Community

Red Light Camera Got Me I Think :(

KrazyKong

By KrazyKong,
in Queensland

 Share

Recommended Posts

KrazyKong Proficient

KrazyKong

Posted
  • Author
Posted

You're apparent advice has to be taken with a grain of salt to be frank. How is it that you have a chip on your shoulder, you weren't involved in my situation nor do you have any vested interest in it. You do seem though to like to post and have a go at people. And then decide they are just trolling and sit back and have a go at them some more. If you can get that worked up over someone who posts details about a situation they have gone through, when it wasn't in any way related to yourself, I'd hate to be around when something happens that is related.

So you had a go at me because I saw an orange light, did not know how long it was orange for, and thus tried to brake, but couldn't' stop before the line, and then went over the line 1 second after it turned red. Then admit you ran a red light yourself and didn't even know you had run a red light until you got a ticket. Keep your advice, it sounds like you need it more than I do.

t5iv Grand Master

t5iv

Posted
Posted

You've run a red in an area that you claim to be notorious for traffic cams.

1. You ran a red

2. You were aware that the cam was there hence how you knew that it was notorious

3. You keep reiterating the same point seeking a different result.

If you haven't had any fines in all these years, 1 red light slip up isn't going to affect you.

Still failing to see what your point in all this is.

RandomHero83 Veteran

RandomHero83

Posted
Posted

Insanity is repeating the same thing over and over expecting a different result - Einstein

You ran a red and got a fine, stop QQing like a girl and take it like a man - Me

Col Please close this thread before some of the pro trolls decide it's open season.

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Nismo GT Pro LSD configurations

      By GTSBoy · Posted

      Well, the trouble with that ^^ is: The configuration shown is absolutely a 1-way, not a 1.5-way. There is no way that a 1.5-way can be said to offer LSD action only on acceleration. If Nismo cannot get that right, then it is impossible to believe their documentation. That ^ is not a 1.5 way setup. That is a 1-way.   And so now I have allowed all doubts to flourish and have gone back to look at the MotoIQ video. I originally made the mistake of believing him when he said "this is a 1.5-way" at the ~6:10 mark. Because what he did was take the gear assembly out of the 2-way opening and just rotate it one place to the left to drop it into the 1-way opening. When he dropped it in there, the cam was "backwards" compared to the correct orientation shown in all other photos of that config. The flat shold have been facing the 1° ramp side of the opening, not the 55° ramp side. And I thought, "gee that's cute", but I was concerned at the time, when he put the other ring back on, that the gap between the rings looked like it was wider then in the 2-way config. And then I said a lot of things in my long post on Tuesday that could only make sense if the guy from MotoIQ was correct about what he'd done. BUT... I have now done my homework. I grabbed a frame of the video with the 2-way config, and then grabbed another with the "1.5-way" config, snipped out the cam and opening of that frame and just pasted it direct on top of the 2-way config. I scaled it so that the triangular opening was almost exactly the same height in both. AND.... the gap between the plates is wider with the cam installed in the triangualr opening backwards. That is.... it cannot go together that way. There would be massive force on the plates all the time, if you could even reassemble it.  So, My statement on the matter? The Nismo diff is actually only a 2-way and 1-way. There is no 1.5-way option in it, regardless of what they say. Here's a photo of a real 1.5-way ramp opening from Cusco (along with the 1 way option). And the full set of 1 through 2 way options from their racing diff, which is not same-same as what we'd typically be using, but...the cams work the same. A little blurry, but it comes from this Cusco doc, which is quite helpful. AND.... Cusco do in fact do what I suggested would be sensible, which is to have rings that do 1 and 1.5, and 1.5 and 2. Separately.  
    • PranK
      Hello sau 👋

      By PranK · Posted

      Welcome Adam. Car looks great!
    • Kinkstaah
      Nismo GT Pro LSD configurations

      By Kinkstaah · Posted

      "With a 1.5-WAY, the LSD is effective only during acceleration."
    • TurboTapin
      Nismo GT Pro LSD configurations

      By TurboTapin · Posted

      Well it wasn't as easy as I thought.... and it also wasn't in my original manual which I did end up finding. They discuss the process in the Nismo catalogue though and it requires slight machining. Page 145.  NISMO PARTS CATALOGUE 2020
    • TurboTapin
      Why am I hitting a power wall with my stroked RB25?

      By TurboTapin · Posted

      I'm an idiot, my intercooler is rated for 1000hp. I had clicked on the wrong product. Knowing the delta P would be nice, but I'm doubtful I'll do it. Now as for an EMAP, that would be great and I'll get around to it eventually but from my findings in my last post, I'm considering a turbo swap now. 
×
×
  • Create New...