Jump to content
SAU Community

Recommended Posts

Was bad earlier

The theme of the party was Glitz and Glamour so Melisa put some glitter glue on her face and shoulders before the party

Got very pissed and scored a lift home

Buuuuut Melisa woke up at about 730 in agony cause some had gotten in her eye whilst sleeping and had to go to the John Hunter

Was there till lunchtime and she now has a week off work an eye patch and a very scratched eye

Picked up the car got a feed, went back to sleep and just got up now

She should be fine in a few days

Have to go back to the hospital in the morning to get checked again

Thanks man

I saw the pic on FB and instantly blamed you, at least we now know it was an innocent injury lol... Let us know how she goes mate!!! :/

If no one has one, take it for a drive to Hunter Thomas Automotive, they have one.

On a seperate note, i've started maping a few possible cruise routes on a map (will upload when i have time) - whats everyone's thoughts on length - i.e. i was thinking keep it under a 300km round trip?

If no one has one, take it for a drive to Hunter Thomas Automotive, they have one.

On a seperate note, i've started maping a few possible cruise routes on a map (will upload when i have time) - whats everyone's thoughts on length - i.e. i was thinking keep it under a 300km round trip?

Unless you want me refuelling all the time..... Yes :P i dont mind! Although cruising will be limited for me for a bit until i do repairs man!!

Photos are slowly going up on the wrap up thread guys but i dont know how many i will salvage :( Sorry!!

lol - yeah thats a good point about fuel consumption

still sorting the suspension or something else playing up?

Bad fuel killed it, need to pump the tank dry and change plugs etc to hopefully sort that out.

Need to replace the coilovers as the rears are dead from Texi..... Properly dead haha

I think 16 cable ties should hold the BOV down temporarily thanks to Chookie :woot:

post-47580-0-58807200-1342501675_thumb.jpg

i've started maping a few possible cruise routes on a map (will upload when i have time) - whats everyone's thoughts on length - i.e. i was thinking keep it under a 300km round trip?

Sounds like a good distance to me

I think I posted one in here somewhere as well not sure of distance though

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...