Jump to content
SAU Community

Recommended Posts

URAS-R33-kit.jpg

So I've nearly stripped my R33 Skyline down to a shell. I figured now is a good time to put it up for grabs!

It's a 1993 Series 1 R33 Skyline, factory turbo and all that jazz.

It left the factory in Burgandy, but the car was painted in a colour similar to bayside blue a few years ago.

It has just run out of rego (3rd August). So it's quite easy to get registered (no defects or anything against it).

It does not have an engine, gearbox, diff, R33 brakes (will have stagea brakes supplied) and other misc parts (some interior pieces etc).

What it does include is:

IMG_3740.jpg

IMG_3743.jpg

IMG_3744.jpg

Wire tucked engine loom

Done by Dahtone Racing, the loom is completely hiden in the engine bay, re-routes the fusebox to the interior and tucks part of the loom above the drivers side wheel arch.

IMG_2618.jpg

Nissan Stagea rear subframe

This completely ELIMINATES HICAS! no lock bars and utilises toe rods instead. It also extends rear track 40mm total (20mm each side).

Uras-slam-R33.jpg

Origin 20mm fibreglass front guards

A little beaten up, but close enough.

URAS-slammed-R33.jpg

URAS Type 4 front bumper

Don't have an OEM item (pictures show URAS sides and rear too, will include for extra $200)

DahtoneRacingintercoolerpiping.jpg

Modified front reo

designed to work with the Dahtone racing short intercooler kit, custom made for this car (intercooler kit extra $300).

Most interior pieces

Standard seats front and rear, dash and door trims are all there, Most boot trim too. Some misc pieces missing and carpet removed.

All in all, the shell will need a bit of TLC to get it looking tip top, there are a few blotches of sikaflex around it, due to the PO having a aftermarket sideskirts, pods etc. The paint is in good condition as you'd expect though.

Price: $1500 or nearest offer. If the price is right I might even chuck in some spares that haven't sold yet.

Located in Liverpool region.

P.S the car is currently on jackstands, and will be rolling within a few weeks. If you are super keen on getting it ASAP I can make this happen quicker.

Aditional photos avaliable on request.

Hit me up!

Adam.

  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...