Installing Hks Boost Controller On Rb26

[toy515]

Hey guys just wondering where to hook my vacuum lines up to, I've got the old hks one with the little square box solinoid I've got rid of my standard lines

Cheers

[XKLABA]

T off the factory boost signal at the back of the balance tube

[toy515]

Yer but I'm not sure what port from the boost controller goes where

[XKLABA]

uh ha, which HKS EVC do you have

if this is the controller you have then on each port is a symbol

B is for the boost/vacuum signal line, run that to the back of the little steel pipe sticking out the back of balance tube towards the firewall

I is for boost in, to give pressure to the unit to pass it onto the waste gates, run that to the smaller of the two pipes sticking out the bottom of the plenum near the brake master cylinder

O is run to the waste gates, I run this one to the middle pipe that runs around the back of the motor

don't worry to much about how the picture is setup it is for a different waste gate setup, and is just to identify your unit

[toy515]

Nah I have the older unit it looks like something from 1980s haha