Jump to content
SAU Community

Recommended Posts

My 2003 V35 Coupe has a noticeable delay when shifting from Reverse to Drive - wait, wait, wait, ok I'm ready now:). It doesn't always do this, but often enough to be a pain. Is this "normal", or should I be worried? Shifting during normal driving seems fine.

Also is there an easy way to ID the trans fluid? The fluid in mine doesn't look burnt or dirty, nor does it smell burnt. It is a light brown / honey colour, not red as I would expect from "normal" (Dexron) trans fluid. I believe it was replaced around 4,000 km ago, but I don't really trust that. What colour is the Nissan Matic J fluid, and the Nulon Synthetic?

Thanks

It's red of course, just like any trans fluid. It would be nearly impossible to ID what is currently in your sump but it can go brown quickly.

I wonder if the shift linkage needs adjustment, or the switch on the valve body... What state are you in?

Scotty - I'm in SA. The fluid isn't a dark brown, more a light honey colour, almost clear. Looking at the colour I doubt that it was ever red. Are you saying that both the Nissan & Nulon fluids are red when new?

Edited by GeeDod

As far as I know, I have never used the matic J, only the Nulon recently but every auto fluid on the shelf I have used was red. CVT would obviously be different.

I doubt the fluid is causing the delay into reverse, more likely something blocked in the valve body.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If I drove to a typical petrol station, what would my choices of fuel be? 
    • Just cut the bottom of the guard out. It's no longer got a big duct, to a sealed box, or a restriction. It has all the cold air from outside. Also, that cai you showed looks terrible. Bends are NOT good for go gos!
    • Like I said, "black magic" LOL In the end,  it is what it is, and hopefully, what this here knuckle head has done is an improvement and not a hindrance Not that I actually notice any negatives now, or that I will get any seat of the pants benefits when all is said and done, but best practice says I shouldn't be pulling intake air from the hot engine bay  Famous last words: I cannot see it being any worse than what it is at the moment 🤔
    • If the gases flowing in those two tracts had the same properties, you could maybe use such broscience. But the exhaust has a different composition, different normal density, different actual density (because of different normal density, and mostly because of the massively higher temperature), and different viscosity (again because of much higher temperature). Consequently, all of the fluid dynamics parameters that matter, that you calculate from these inputs, such as the Reynolds number, friction factors (for wall friction) and so on, are all incomparable.
    • And we shall have to presume that Canada is the same?
×
×
  • Create New...