Jump to content
SAU Community

Recommended Posts

  • Hi Scotty, I am in need of the tailshaft centre bearing. Mine is shot. Looks like the whole 2 peice shaft has to come with the bearing as it is pressed on and the bearing is one peice with the carrier?
  • Does the wreck have a good tailshaft and bearing? it is a lot to ship to wollongong but sounds like it is the only option for me.

It should be ok, the rear had a shunt but the rear subframe seems to be unharmed. I will have to rip it out and have a look. All you will need is the rear part, the front will unbolt from it.

I will PM you when I get time, or just contact me if it's urgent.

I have a spare one here, or I can fabricate a shiny new stainless 3 inch one, what are you after?

haha im actually trying to fabricate my own 3inch but just needing a old stock section for something to look at :D

i have recently learnt how to tig weld and hoping to save myself some cash lol

  • 5 weeks later...

There are always some on ebay, it will fit many more models i'm sure. Even the micra one looks the same. Just check the part numbers...

http://www.ebay.com.au/itm/Air-Flow-Meter-AFM-Genuine-Nissan-Pulsar-N16-Sedan-Maxima-A33-12months-Warranty-/120817573664?pt=AU_Car_Parts_Accessories&hash=item1c2149df20&_uhb=1#ht_2430wt_1159

Perhaps even cheaper in the US? I have no need for one anymore so i'm no help... :)

Mmm, not sure. I will have a look. Are you planning to run the rear heater vents on a car without it? Interesting...

looking for vented arm rest with asociated tubing so it can vent to rear passengers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
    • Yeah, I would have said the same. It makes me suggest that there are other things wrong, such that the ECU is totally unhappy with the broken sensor. The only other thought here is that maybe it is shorted, which might cause a different issue to the typical "disconnected" sensor.
×
×
  • Create New...