Jump to content
SAU Community

Recommended Posts

Shiiiit. It bolts on right at the top of the gearbox. I wish I had of bolted that on before putting the motor / gearbox back in the car. :stupid:

I will have to find somewhere else to install it.

1 of the top gearbox bolts, can't remember what side but it'll be whatever side it reaches. It sits between the bolt head and the gearbox, like a washer.

EDIT: Beaten to it.

Edited by JonnoHR31

Should have a bracket attached to it and bolts into the top right hand side bell housing bolt

Wrong section too :)

Woops, didn't think of putting it in the driveline area :/

But thanks :)

Thanks for the info guys. Was looking at mine last night trying to figure this out. Also didn't realise it went at the top of the belhousing, which was done back up and now on the motor mounts. Doh! Cable ties to the rescue!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
    • Mark's a bit smarter than people give him credit... He'd convince the person that is to become dead, to drive him to the forest first. That way his car has no evidence in it, and he's free to dispose of their vehicle permanently how he sees fit too...
×
×
  • Create New...