Jump to content
SAU Community

Recommended Posts

To give you an idea...

Southside of Brisbane = Western Suburbs of Sydney

West side of brisbane = Western suburbs of Sydney

Individual burbs...

Caboolture, ipswitch, Logan = Mt Druitt, Bankstown, Merrylands

cheers for the list.

i know those places(nsw one) well, as i used to work in Mt drugit.

and i currently live in west sydney.

just further west than those places.

  • Replies 138
  • Created
  • Last Reply

Top Posters In This Topic

Well I'm at the very north end of Brisbane and it's about an hour drive to the nearest drag strip, Lakeside is about 5 minutes up the road and the 2 best mountain runs are only about 15 min away. So within greater Brisbane you will be about 1 hour from the drags.

cheers, i can live with an hour.

i think im about 1/2hr from eastern creek where i live atm.

Yes, but north Brisbane is close to Lakeside and QR/Drags. Sunny coast is nice but go farther north than Caboolture if you do.

Avoid Noosa, it's full of hippy bohemian people... Freaks me out lol

My girls gonna be doing her 5 year veterinary doctorate at Gatton starting this year so I'm going to have to move to Toowoomba before years end. How hard is is to find work there and whats the rent situation like?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...