Jump to content
SAU Community

Recommended Posts

Hi there,

I need to route 2 wires from the passenger door into the cabin (addition of central locking).

What's the best way/smartest way of doing this?

There seems to be just this one door connector and it doesn't look tweak friendly

Car is R33 GTSTS2

Thanks!

Edited by Torques

Sorry,

I meant to write the driver side door, not passenger.

To my knowledge there is no 2nd pair which I could use.

Normally there is only that switch which is linked to the door latch.

Now the actuator (from an Almera) fits 100% and includes the switch (which triggers passenger side) but also needs 2 wires for the actuator functionality.

So I need to route 2 wires into the cabin in order to connect it to the alram system.

Sorry for the mixup

.

ah ok. forward of the door boot there is a small grommet. pop the side indicator light out and look back toward the door and it will be visible. bit of twin core jacketed cable throught that and a small cut through the door side of the door harness and you are in.

good to see you worked the actuator out. model changes across countries make things like that hard.

Hi Chris,

Thanks for the input, will get to it in a minute.

(Can't wait to have a proper central locking)

Yes, a Nissan Almera (1995) doorlatch was exactly what I needed.

The actuator fits right in .. works beautifully.

:)

On the left the Skyline locking switch, right the Almera actuator (4 wire)


post-33912-0-17940000-1361009995_thumb.jpg

Edited by Torques

Thanks,

all done now, works very smoothly and without any noise.

It's been a bit of a job since I had to revisit my alarm system wiring which had not been finished until the actuator was installed.

This 'mod' really propelled my car into the 21th century :)

Gone are the days fumbling with that key ..

post-33912-0-29154600-1361376519_thumb.jpg

post-33912-0-10405900-1361376523_thumb.jpg

post-33912-0-88094800-1361376525_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
    • Haha, that's so true. Minimal plans quickly turn into a full transformation, especially when you see what others are doing
×
×
  • Create New...