Jump to content
SAU Community

Recommended Posts

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

hey d_Liberate, the group buy still going? I'll also take a set (r34 rb25de/det) I don't have the YJ part # on me though.

only issue is... its easter weekend and banks are closed. couldn't go to a bank to pay until at least Tuesday :wacko:

  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 1 month later...

I havent had any interest since my last post so u are probably better off getting a set straight from performance-wise.

I would mind a new loom myself too. I didnt realise they had them for sale. good to know.

I didnt get much of a response from the other members re the YJ GB yet.

I cantacted PW and he said hed be happy to do another GB for 5 sets of coils.

For the looms, he said doesnt have much room to go down on the price but if he can get a minimun of 6 buyers, he can take $20 off the price.

He also said if you purchase a set of coils and a loom aswell, he can take $10 off the postage cost of the loom..

They seem to be good quality too with a good warranty etc..

I know im keen to get 1 so who else? If we get enough definite interest, I will start a GB thread for both the Yjs and the looms.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...