Jump to content
SAU Community

WTB: APEXI POWER FC+H/C & APEXI BOOST KIT FOR R33 GTR


Recommended Posts

Power FC & HC + boost controller for $1150 delivered

Hi,

Im not after the apexi boost controller anymore as a lot of people have advised me that they dont hold boost to well on GTR's. I can offer $800 C.O.D for the PFC & HC.

Thanks.

Guest two.06l
Im not after the apexi boost controller anymore as a lot of people have advised me that they dont hold boost to well on GTR's. I can offer $800 C.O.D for the PFC & HC.

Thanks.

another silly unsubstanciated claim on the forum

we run an apexi avc-r on staceys race car.we are currently running 25psi and it uses exactly the same solinoid as the power fc kit does.graphed the boost levels on croydons dyno and dont think i have seen a flatter boost line(dead straight on max boost).with her new turbo upgrade we are confident of upping the ante to 30psi.hope this has helped with your decision.

another silly unsubstanciated claim on the forum

we run an apexi avc-r on staceys race car.we are currently running 25psi and it uses exactly the same solinoid as the power fc kit does.graphed the boost levels on croydons dyno and dont think i have seen a flatter boost line(dead straight on max boost).with her new turbo upgrade we are confident of upping the ante to 30psi.hope this has helped with your decision.

Hi,

Thanks for your input. I was advised that its not to do with how much boost your running but to do with the springs in the actuator. With the factory actuators they start to open around 10-11psi so the boost controller struggles to hold more boost at stable levels such as 15-16psi. Correct me if i am wrong. I do appreciate other peoples opinions.

Guest two.06l
Hi,

Thanks for your input. I was advised that its not to do with how much boost your running but to do with the springs in the actuator. With the factory actuators they start to open around 10-11psi so the boost controller struggles to hold more boost at stable levels such as 15-16psi. Correct me if i am wrong. I do appreciate other peoples opinions.

yeah fair point we have hks actuators on that car.......but.last weekend we set an avc-r up on one of our other gtrs running stock turbo/actuators and works great at holding 1.1 bar and car ramps up to max quite quickly.the comment in this thread advised that it was the apexi that was at fault and this is not the case,as you have just pointed out.cheers and good luck with your setup.

I can see where your coming from. If i can find an apexi b/c with the pfc and h/c as a whole kit i guess i will still buy it, but if i come across a dual solenoid b/c before hand i'll get that. Thanks again for the info.

Guest two.06l
I can see where your coming from. If i can find an apexi b/c with the pfc and h/c as a whole kit i guess i will still buy it, but if i come across a dual solenoid b/c before hand i'll get that. Thanks again for the info.

no worries,any probs with the setup pm me as am glad to help out. paul (staceys pit bitch)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...