Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Nick, Ben did a [email protected] at Jambo in an RB26 powered R32 GT-R. What's your dirty old pushrod motor got now?

Fastest LS1 in Australia is 6.8, jus sayin.

Of course I have no idea who ben is or what class it ran in!

Edited by Bunta

I said 'your,' meaning Nick's motor.

phew! Thank gawd for semantics :P

Fair enough, in that case compare him to a stock R32 GTR...which is still a good half second faster down the 1/4 :P

Fair enough, in that case compare him to a stock R32 GTR...which is still a good half second faster down the 1/4 :P

Which explains why Chris's v spec was in the high 14 and toms 33 with n1s on it ran identical times to mine.

Yes they can do a 13.0 but nobody will do it cause u might get 3 runs untill u shit something

Fair enough, in that case compare him to a stock R32 GTR...which is still a good half second faster down the 1/4 :P

This is true. I was also alluding to his allegations of RBs being hopeless.

But then you caught out my implied insult to the LS1 :(

Which explains why Chris's v spec was in the high 14 and toms 33 with n1s on it ran identical times to mine.

Yes they can do a 13.0 but nobody will do it cause u might get 3 runs untill u shit something

I have seen with my own 2 eyes a stock one do a 13.2 something and one with a decent clutch and a ECU do well into the 12s.

Those times are....not good. And knowing Chris in particular the launch would have been a softie.

This is true. I was also alluding to his allegations of RBs being hopeless.

But then you caught out my implied insult to the LS1 :(

They could do a 6 second pass, won't change the fact that I broke 2 of them and think they're weak as piss droney horrible sounding boost fed midget motors

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Messing around with. Twin kit for. Rb30/26  
    • For fuelling the Haltechs have O2WB fuel controllers. Very useful for helping tuning VE and correcting for *small* mistakes. Of course if your injector/cam/trigger/sensor data is just wrong (or for a GTT which is not a GT) then you will get impossible reactions to things. I am sure you know this already but the reason people don't typically put haltechs (or any Aftermarket ECU) on GT's is because there's practically no real gains to be had - So this knowledge won't be commonplace.
    • Can someone tell me if the cracks seen in the rear sway bar bushings in these photo's is unacceptable from a roadworthy point of view?  
    • Shouldn't need a "base map" for anything other than guidance to ignition tuning. You just need the engine capacity right, the injector size right, and something, almost anything, for a VE map. On an NA engine, fuelling is almost completely a function of load signal & rpm. It should run and drive with a completely flat fuel map. It will be too lean under load, but that's easily fixed. We used to tune all ECUs without any base map. There were no such things (until someone had tuned a near stock engine on one, and then they had a "base map".
    • What did you actually buy/how much did it cost? When I got mine in like.. 2017...? 2019? the aim was to run Torque for gauges via ODB2 and things like Track Addict/Laptimers/Dashcam/Reversecam/Spotify etc. Mine never broke, but I wonder if you've got the same needs (it sounds like it). Cause I liked the idea of being able to do anything with it. That said, yours also cost 3x the cost of what I spent so... food for thought.  
×
×
  • Create New...