Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Working on the idea of a gt30 but not high boost

high flow from hypergear will be cheaper in the long run, bolt in with less issues and give better response with the power you want. a 3071 is a 270ish kw turbo, will be a bit laggier, and requires custom dump and some other bits to bolt in.

high flow from hypergear will be cheaper in the long run, bolt in with less issues and give better response with the power you want. a 3071 is a 270ish kw turbo, will be a bit laggier, and requires custom dump and some other bits to bolt in.

Just built Pls R34 engine. Fully built Nur block .5 ob nitto internals with a single GTX3071R runs EFlex 389awkw. On the cheap, all fitted tuned etc 40k exercise. Fuel system alone was 11k. Engine and fuel system capable of 600kw +, but turbo limited to 22psi and at max flow.

Just built Pls R34 engine. Fully built Nur block .5 ob nitto internals with a single GTX3071R runs EFlex 389awkw. On the cheap, all fitted tuned etc 40k exercise. Fuel system alone was 11k. Engine and fuel system capable of 600kw +, but turbo limited to 22psi and at max flow.

this rings the bell mate.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
    • A wise man once told me, "Anything you enjoyed wasting was not wasted".
×
×
  • Create New...