Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Nah, I wish I had those kind of skills, a guy in sydney did up a batch for VR4 club members, I just got them back from the ceramic coaters today, only $85 to coat the pair. Good considering the extra 1" of diameter is normally taken up by factory heatshielding

Morning Scottie

Glad to hear you took the 33 out for a spin or spins

hahaha tyres may have been rotating a tad.. Was actually enjoyable to have a drive in it for a change. Havent really overly enjoyed driving it the last few times

hahaha tyres may have been rotating a tad.. Was actually enjoyable to have a drive in it for a change. Havent really overly enjoyed driving it the last few times

don't worry you will get ze poawa back soon mate

11th for me. May wait until that new gov tax thing is online in August though since my tax is very simple.

that is assuming my company gets it right, which may be a stretch since it took them 3 months to transfer over my leave from the old system.

11th for me. May wait until that new gov tax thing is online in August though since my tax is very simple.

that is assuming my company gets it right, which may be a stretch since it took them 3 months to transfer over my leave from the old system.

your old leave does not effect your PAYG Payment summary for last FY Pete.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • As MBS suggested if this is happening when the engine is cold you're going to want to remove the intake air regulator and verify resistance + that the shutter is physically opening and closing. At -20C should be fully open, 20C half open, over 60C fully closed. At 20C should be 70-80 ohms. For AAC valve testing using a Consult cable see if you can raise and lower the idle by commanding more or less AAC duty cycle. Hopefully it's pretty linear as well, shouldn't be like 30% AAC valve is barely idling and 40% is 1500 rpm.
    • Bloody apprentices! 🙄
    • Not sure yet.  Was considering speedtek because it was rated to 800hp, but when I did some research about him I don't think I will go for that🤣 So maybe giken gear set, but I'm afraid it won't be strong enough🙄
    • Keeping in mind that for most people this is a week to month long job!
    • Its also worth mentioning that 30 years after it left the factory and god knows how many missed oil changes since, there is every possibility that one or more lifters are ticking because they are sticky/gummed up. To resolve that you need to pull the cams then pull each lifter, disassemble, clean, reassemble, soak in oil and re-install, and they should come up good as new.
×
×
  • Create New...