Jump to content
SAU Community

Recommended Posts

Secondhand Alpine V12 MRV-T505

or

New Response 2x150rms

$225 for the alpine and $239 for the response

but which would be better to get.. i dont mind the secondhandy if its miles better than the response.

i am running a pair of MB Quart Splits with it

Find out which of these amps:

Has an unregulated power supply

Delivers the most current

Is stable at lower impedances.

The amount of current an amplifier will stably deliver is more important in determining how well it will handle transients & "grip"your speakers than an RMS wattage rating. An unregulated power supply means more current to your speakers ( therefore more headroom for transients) with higher battery voltage. Generally, if an amplifier can deliver more current at lower impedances (2 or better yet 1 ohm) the better. The next most important factor is slew rate (transistor reaction time) lower slew rate is better. Next on the list is THD (total harmonic distortion) expressed as a percentage, lower is better. Channel seperation is next consideration (higher is better).

Have I done your head in yet ? :Bang:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...