Jump to content
SAU Community

Recommended Posts

First thing to do:

timing belt, water pump

Reason why?

Most imports have had their clock wound back, or clusters have been replaced

Then:

  1. Full exhaust (just get 2nd hand) ~$500
  2. Intercooler of some sort, even a R34 GT-t side mount $100
  3. Hit up Toshi for a socketed stock ECU with a new ROM tuned for AU 98 Octane fuel ~$350
  4. Turbotech MBC 0.8bar ~$30
  5. Fry tyres ~Priceless

The only thing I would add to that is a new fuel pump. The second worst thing that can happen to a 20 year old car after a shredded timing belt, is a failng fuel pump.

Edited by Missileman

Johnny's list is solid.

If you want to go further than that you will find out that everything on the R33 has been sized just right for factory output plus a little more. Figure out what your ultimate power goal is and work back from there to see what needs to be done.

This times 1000!!! I spent about 20 grand on mine when I bought it. Thinking back now could of saved a lot of time and MONEY by researching more. I would of saved about 8 grand and over a year of time for a better result.

Ha ha. I also would have saved a bucket load. 3 turbo's before i reached my power goal,

Part of doing timing belt and waterpump is replacing cam seals. They will leak, they cost less than 10 bicks each and you have to take timing belt off to do them, so do then at same time.

First thing to do:

timing belt, water pump

Reason why?

Most imports have had their clock wound back, or clusters have been replaced

Then:

  1. Full exhaust (just get 2nd hand) ~$500
  2. Intercooler of some sort, even a R34 GT-t side mount $100
  3. Hit up Toshi for a socketed stock ECU with a new ROM tuned for AU 98 Octane fuel ~$350
  4. Turbotech MBC 0.8bar ~$30
  5. Fry tyres ~Priceless

Who's Toshi? lol

P.S Thanks for the help fellas!

Just a thought, see if you can pick up an rb20det turbo actuator and swap it with the rb25 turbo actuator. I've seen the individual actuators sell for around $50. The rb25 turbo actuator is set on roughly 7 psi whereas the rb20 turbo actuator is set on 10 psi.

Just a thought anyway.

Part of doing timing belt and waterpump is replacing cam seals. They will leak, they cost less than 10 bicks each and you have to take timing belt off to do them, so do then at same time.

Agreed, mine leaked at about 160k and they were rock hard. Chalk that up as number 6 on the list of things the dropkick knuckledraggers I took it to for the 100k service didn't do properly.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...