Jump to content
SAU Community

Recommended Posts

Hey

I get my car in a week and i want to put redline oils in the engine, gearbox and diff.

To my knowlage everything is ok, no gearbox crunching or whatever so i wont need lightweight shockproof.

But im after the best redline oils for my car, so if you could tell me wats the best to use and since is the 1st time ill service my car, how much oil do i have to put in my engine, gearbox and diff.

If anyone can tell me ild be greatful :D

Oh and its an r34 gt-t turbo manual.

thanks

Brendan

Link to comment
https://www.sau.com.au/forums/topic/43650-what-oil-and-how-much/
Share on other sites

I cant help you with Redline,

But the best oil you can buy for an r34gtt in my opinion is Motul 300v Chrono

Its $40 per 2L

Hard to find, but is seriously worth it, i have dead-set noticed a different since putting it in a few months ago. My car made 166.6rwkw with only a cat back and pod filter, no intercooler or boost.

Oil is like the engines blood, you want the best you can buy.

my 02c

I use either Motul 4100 ($50) or Motul 8100 ($70) depending on what my driving will be like for the following month(s). You can pick it up / order it at your local Autobahn (in Sydney anyhow).

The Redline Shockproof gearbox oil is ~$110 and you can buy it from www.nismo.com.au or CRD at Silverwater in Sydney.

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...