Jump to content
SAU Community

Rb26Dett Problem Starting When Warm

BoostedBarge

By BoostedBarge,
in General Maintenance

 Share

Recommended Posts

BoostedBarge Rising Star

BoostedBarge

Posted
Posted

I have a Stagea 260RS with a RB26DETT. It's had a Vipec V44 fitted for 5 years or so now. One thing that has always bugged me and I haven't been able to solve is engine starting when warm. If the engine is cold, it starts straight away. If I shut the engine down and start it 10s later, it starts straight away. If I shut the engine down for a few hours (sometimes up to 8 hours) it always takes a lot of cranking. At first I thought this was a tuning problem and my tuner added more cranking fuel. It may have made a minor difference. A friend and I had another go at it 6 months ago and added more fuel. It seemed to improve the case where you shut down for 10s, but still if the car has been left for a while I have the normal problem. When it does eventually splutter to life, it pumps out a bit of black smoke, so I'd say we've gone too far with the fuelling now. I'm beginning to think this is not an ECU problem, so I was wondering if anyone on this forum might have some ideas of what else I can check. I was thinking it could be an injector that is slowly passing when the engine is off. I had all injectors cleaned and tested when the ECU was fitted, but perhaps they didn't pick or test for this. Any other ideas?

Link to comment
https://www.sau.com.au/forums/topic/437453-rb26dett-problem-starting-when-warm/
Share on other sites
Ben C34 Grand Master

Ben C34

Posted
Posted

I think it would be tune issue. It's hard to set up all of the parameters, and to get it nearly as good as factory is really hard.

I am suprise the cold start is good, usually that's the difficult one to get right.

GTRPSI Mentor

GTRPSI

Posted
Posted

How does is sound while cranking warm, does it sound like the starter struggles a little to turn the motor over, sort of like the battery is losing its balls a little? If so pull some timing out and try again.

Of course if you have a leaking/stuck open injector thats another matter......

Shoota_77 Veteran

Shoota_77

Posted
Posted

As per above I would look at injectors as a possibility. A dribbly injector/s could cause that. Are you running a higher fuel pressure than standard? Could be forcing fuel through the injectors when parked. Does your oil smell really fuelly??

Dose Pipe Sutututu Grand Master

Dose Pipe Sutututu

Posted
Posted

I would play around with the temperature vs. injection correction table...

when your car is hard to start, pay attention to the water temp logged, then go to that point and try tweak the cranking injection & also the fuel correction for that temp

BoostedBarge Rising Star

BoostedBarge

Posted
  • Author
Posted

Cool. Thanks for the feedback guys. The starter motor never seems to struggle. It cranks quite easily, but just takes a while to eventually start. Fuel pressure is standard. The oil doesn't smell fuelly, but I might check it again.

I'll check out the coolant temp correction, etc.

Dose Pipe Sutututu Grand Master

Dose Pipe Sutututu

Posted
Posted

Also if it starts easier with a little throttle applied, I would have a look at the AAC or IACV and give them a test/clean.. there should be some high idle dwell on start up.

I'm not too familiar with your ECU but other ECUs there's an idle dwell which you can adjust which applies a little throttle on startup and dwells a little before dropping to your predefined idle setting.

BoostedBarge Rising Star

BoostedBarge

Posted
  • Author
Posted

Also if it starts easier with a little throttle applied, I would have a look at the AAC or IACV and give them a test/clean.. there should be some high idle dwell on start up.

I'm not too familiar with your ECU but other ECUs there's an idle dwell which you can adjust which applies a little throttle on startup and dwells a little before dropping to your predefined idle setting.

That's quite a good point about the idle up on startup. I might look into that..

  • 8 years later...
West Grand Master

West

Posted
Posted
On 4/28/2022 at 11:03 AM, BoostedBarge said:

Sadly I sold the car in 2016. I honestly can't remember if I fixed this problem. I don't recall doing the AAC or IACV. Maybe we tuned it out on the Vipec.

Ah ok thanks
I'm having the exact same problem, cold/hot start like a dream, when its mildly warm she struggle and when start, RICH as fk.

Dose Pipe Sutututu Grand Master

Dose Pipe Sutututu

Posted
Posted
On 28/04/2022 at 11:26 AM, West said:

Ah ok thanks
I'm having the exact same problem, cold/hot start like a dream, when its mildly warm she struggle and when start, RICH as fk.

Your cranking table and prime table needs work.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GoHashiriya
      From Japan and back to Europe, my sh*tbox R34 GTT

      By GoHashiriya · Posted

      Cheers. Skyline is back on the menu, can’t get rid of it. It’s like a child you don’t want, or herpes 
    • Dose Pipe Sutututu
      From Japan and back to Europe, my sh*tbox R34 GTT

      By Dose Pipe Sutututu · Posted

      Welcome back brother 
    • GoHashiriya
      From Japan and back to Europe, my sh*tbox R34 GTT

      By GoHashiriya · Posted

      I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • GoHashiriya
      From Japan and back to Europe, my sh*tbox R34 GTT

      By GoHashiriya · Posted

      It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
×
×
  • Create New...