Jump to content
SAU Community

Recommended Posts

Hey guys,

Currently doing a engine rebuild/single turbo so need to sell stuff to fund....

RB26 Turbo kit. 2560s, Stainless split dumps, exhaust manifolds and front pipe. $500. One turbo is seized other is OK. Rebuild and then have a cheap turbo kit. Was never boosted above 16psi.

R32 GTR Intake piping&Pods(everything from turbos to pods, afms included) $350

If you want the turbos and intake piping, will do it all for $750

R32 GTR Stock intercooler piping, $250

R32 GTR Dash cluster showing 149k. $200

R32 GTR Dash cluster showing 119k $250

R32 GTR Stock Electric Mirrors(Black) - Good cond, $250
Alpine Type R 15" 1000rms - New. $300
R32 GTR Stock ECU $250
RB26 Stock cam shafts $100
R32 GTR DBA4000 rotors, $25 each or all 4 for $75. Will need to be machined.

R32 GTR Rims 16x8+30 with Full Slicks. 1k. All center caps. Good condition.

Set of 4x114/4x100 Rims, white inners chrome lip. 17x7+35. $400 nego. no tyres pics on request.

Standard S15 brake calipers, $50

Monza fuel pressure reg with lines. $40

3" Straight through cannon. $100

3.5" Straight through cannon $150

Unpunched Nissan Stock cat convertor. $250 two of them for sale.

FULL R34 Auto Wiring loom - From fusebox to ecu. $250

Rb20/25/26 CAS (Cam angle sensor) $150. Used but good condition

Metallic sump plug for R32 gtr $50 - new in packaging

6x Matte Red cans of Plastidip

6x Blaze Green cans of plastidip. All cans $30 each

6x Clear Matte

Will swap items for a Single turbo capable of 750hp+ or a set of coilovers for R32 GTR with cash either way.

Most prices are negotiable, ask. Worst I can say is no. Shipping available on most items at buyers cost.

All items located Sutherland shire NSW or Ultimo. Alternatively, travel to ACT every two weeks for work.

Will add more bits as I find them!

Link to comment
https://www.sau.com.au/forums/topic/438994-r32-gtr-parts-for-sale/
Share on other sites

  • 3 weeks later...
  • 2 weeks later...

BUMP.

Also now have:

R32 GTR coilovers. HKS Hyper-D. Not sure on spring rates. Were not too stiff just right. Only selling as upgraded to buddy clubs.
Some surface rust as visible In pics. $450 located Sutherland shire. No knocks or anything

post-81745-0-48030700-1396309789_thumb.jpg

post-81745-0-86698400-1396309790_thumb.jpg

  • 1 month later...
  • 1 month later...

R32 GTR rims with slicks sold.

Everything else still available!

Also have basically everything from twin turbo setup for sale (minus turbos dumps etC) all intake, i/c etc. Make an offer worst I can say is no.

Also 3 Bar Haltech Map sensor, $100

Thanks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...