Jump to content
SAU Community

Recommended Posts

  • Replies 50
  • Created
  • Last Reply

Top Posters In This Topic

You will hit limiters/cuts before you boost the turbo that high that it breaks :Oops:

Im fairly certain 14psi is the limit for all of the GTST/GTT series, altho the difference between 12psi and 14 is very little with the standard turbo.

I hit 0.95Bar on my car last nite on the freeway, didnt have any problems at all, and it pulled very hard. But ide never run that boost during the day or anywhere other than the freeway.

If your on the freeway cruising, at night, with a nice intercooler and cold inlet temps, then give 14psi a go, otherwise stick to 12psi

my 02c

Accepted practice is about 12PSI max on standard turbos, but since each turbo is slightly different, it could be more, it could be less :)

I wouldn't go for 14 personally, but I don't have deep pockets to replace something if it goes wrong..

LW.

I am running 15 psi, with a cold air box and good FMIC. My PFC is also tuned to dump a lot of fuel at those boost levels to try and keep the temps in the zaust side of the turbo down.

I think that with a good FMIC and CAB you should be able to run 14 psi if you dont cane the Sh8T out of it all day every day. 14 psi on the track would not go down to good I would think.

Mate stick to 12 - 12.5 you don't want to kill it straight after you got it. Anymore than that with the stock ECU and all sorts of funny things start happening. I had a horror day when I set my AVC-R to .95 bar and did 10 laps of Wakefield. It spat the exhaust/turbo gasket, intercooler hose and the dummy generally.

Hi Driver, R34 GTT 12 psi for 5 laps at Wakefield Park and one ceramic turbine in the cat. :spew: That's with a good intercooler (R33 GTR), good tune (not by me), oil cooler (Earls), POD with good ambient air intake (by me), standard dump with hi flow cat and 3" exhaust (HKS) and a GTR fuel pump. It wasn't being pushed super hard at the time either. I can give similar examples, the HPI R34 did the same thing and I have personally seen 3 X R33 GTST's with the similar results at supposedly "safe" boost limits.

Bottom line, I wouldn't go over 10 psi for any extended periods. :Paranoid:

If you have an intercooler (check), an air filter (check) and a full exhaust (check) then shoudlnt you be running about 11-13psi anyway? Without even touching the wastegate line.... i was on my R32 GTST, though i think they run a lightly harder spring.

Yep only on R32's, R33's and R34's (especially) don't repond as well and have softer wastegte actuator springs. :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...