Jump to content
SAU Community

Recommended Posts

Hi,

Hope someone can tell me the easy fix for this problem or solution.

My gearbox makes whiny scraping noises when I put the car into gear and get off the clutch.

Doesnt feel like anything is wrong but im not sure what damage it can cause on the inside.

Thanks for any replies.

Link to comment
https://www.sau.com.au/forums/topic/450645-gearbox-noise/
Share on other sites

maybe try to take a decent vid/ audio of it and also flesh out a few details like I said above.

They are 15-20 yr old cars now and they do make many noises...

Otherwise, one of my first recommendations to anyone purchasing a skyline is to go and dump the gearbox oil and put in some fresh high quality synthetic stuff. They are old cars and have probably gone a long time without an oil change in the gearbox or diff. Changing it will make the gearbox so much nicer and also fix many niggles in the synchros.

At the same time you can have a mechanic test drive it and give you a recommendation on what the noise my be and fixes.

Has the clutch been replaced/upgraded at any point?

Link to comment
https://www.sau.com.au/forums/topic/450645-gearbox-noise/#findComment-7425234
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
    • Yes. You will need to get the original boost sensor and wire it in. That is.... if you plan to use a stock ECU - even a Nistuned ECU. The Nissan ECU will not operate correctly without it connected. And yes, it will do annoying stuff like you are experiencing. You will almost certainly be better off with some aftermarket ECU, than trying to hunt down rare sensors.
    • Ok so ABS/TCS is "not" the problem. Yeah i know now about the ABS with Nistune(i told that to the Nistune guy) but iam not 100% why or why i dont have ABS. ABS cube is in the engine (always has been) but i had braked couple of times rly hard and brakes just locked and scream. Does all Skylines have ABS cube? That boost sensor https://www.sau.com.au/forums/topic/367633-wtb-r34-gtt-turbo-pressure-sensor-pics-inside/ Is this it? I need to ask but i have a picture of engine bay and i do not see that (100% is not in that place) If i do not have this the car can do what mine is?(cutting around 4000 rpm) Here is the pic of my engine bay(only one i have) BUT i think i dont have that cuz loom was used from my RB20DE NEO and i know (obviously) that it does not have boost control or any wire to that...) so maybe that is the problem? (i dont know for 100% if that car where the engine is from had that)...but i dont have the loom from that
    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
×
×
  • Create New...