Jump to content
SAU Community

Recommended Posts

Hey guys quick question stupid me.

for some reason my R33 gtr seems to not have the "Standard Brembo factory" brakes. mine have nissan ones.

were brembos factory all round.

also my R33 was registered as a 1997 R33 gtr.

97 should be around when S3 where made.

But mine is clearly a S2 i knew this upon purchase but just seems odd that a 97 mine is a S2 not a S3 unless it was made just at the start of 1997 before S3 came along. can anyone confirm the exact date/time they started S3 production? Could mine of been a in the middle of S2 and S3.

  • VIN: 6U900BCNR33042576
  • Vehicle: NISSAN GTR 1997, SILVER OR CHROME
  • Type: CAR/SEDAN, CAR / SMALL PASSENGER VEHICLE
  • Registration: VIC, [no rego plate data] expires [no rego expiry data]
  • Engine: RB26058254A
  • Compliance date: 2003-03

Unregisterd at the moment.

Link to comment
https://www.sau.com.au/forums/topic/454216-help-r33-gtr-brakes/
Share on other sites

1/96 - 2/97 Is the build date for S2 GTR's.

2/97-5/98 is the build date for S3 GTR's.

There is differences between them if you don't know them. All R33 GTR's came factory with Brembos.

Only the R32 GTR came with standard Nissan brakes except if you have a R32 Vspec that is when they brought in Brembos.

To me it seems like the previous owner sold the brembos off as they can sell for a fair amount as an upgrade to other vehicles. But I am unsure why they would put just standard Nissan ones on as they are a downgrade. Probably to sell the car off and make money, not entirely sure on the reason behind the previous owner's actions though.

If your spending a bit of coin on upgrades (that is why we buy these cars) then I would suggest looking at getting some Brembos to begin with or if you have deep pockets you can buy some better kits starting from a few thousand.

That VIN was build in 10/97.

I agree, most likely the person you bought it from pocketed the $1000 for downgrading the brakes :thumbsdown:

Having said that the 32 brakes are fine for street use, and Ksport/ATTKD etc make good upgrades from about 2000

10/97 Would definitely be a S3 GTR. There are a few differences between series two and three.

The obvious one is the interior is red instead of blue but it could have been re-stitched.

A check you can do is with the rear of the car. The outer tailight of the set should only light up unless modified. And you will only have one reverse light on the left as the right side has a fog lamp, which is an orange kind of lense.

Found out its a common thing for people trying to get the most out of them when selling/ also happens at the auctions/docks in japan.


and if you got it for the price i did for the condition the body is in. and the engine leak down test/compression test results and also gear box after i fixed the clutch adjustment. you wouldnt care what brakes where on it. when im going to upgrade them anyways. i was just curious.

  • 6 months later...

I also have a s3 r33 gtr. I have brembo front calipers, but annoyingly have Nissan rear calipers. I assume the rear calipers were swapped for cash or whatever but the rest of the car is mint so the quest continues for original brembos [emoji4]

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Cheers. Skyline is back on the menu, can’t get rid of it. It’s like a child you don’t want, or herpes 
    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
×
×
  • Create New...