Jump to content
SAU Community

Recommended Posts

these are the parts that i have left no reasonable offer denied

rear bar grey in colour bit faded $40

reinforcement behind rear bar $15

front seats out of m spec immac $300

rear seats out of m spec $90

grey carpet $40

grey hoodlining $30

fuel tank with fuel pump and sender $50

rear window $100

left hand quarter window with rubber $50

rear sub frame with hubs & control arms SOLD

gts4 or gtr front hubs control arms and struts $80

ac compressor $40

manual tail shaft $40

all plastics from center console and radio facia

brake master cyl with pipes and abs unit $100

A PILLAR TRIMS $25 EACH

LH POWER MIRROR $40

complete top end rb20det head, manifolds, turbo wiring, computer asking $400

no gearbox

no coils or ignitor

no dash or vents

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/
Share on other sites

is the boot charcoal metalic or gray as described???

Also do you have the metal lining that goes around the rear windo its a three piece metal strip thing???? PM me your mobile and i can have a chat about some stuff and prices!!!

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/#findComment-931254
Share on other sites

Need 2 x o2 sensors out of GTR r32 , the ones that scew into dumps , must be working please.

these are the parts that i have left no reasonable offer denied

boot lid imac with wing off m spec gray in colour $90

rear bar grey in colour bit faded $30

rear seats out of m spec $90

both doors with all internals and glass . no door trims $200

grey carpet $40

grey hoodlining $30

fuel tank with fuel pump and sender $50

rear window $100

rear sub frame with hubs & control arms $80

gts4 or gtr front hubs control arms and struts $80

ac compressor $40

manual tail shaft $40

complete top end rb20det head, manifolds, turbo wiring, computer asking $400

no gearbox

no coils or ignitor

no dash or vents

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/#findComment-931497
Share on other sites

these are the parts that i have left no reasonable offer denied

no gearbox

no coils or ignitor

no dash or vents

What about the underbody plastic bit RHF Guard - protects the BOV are from road dirt?

Odd screws/connectors from the bumper etc?

R32 GTR not sure if other cars are different

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/#findComment-934827
Share on other sites

Hey man if you know if the R32 drivers side window is the same as an R33 and in good condition send pic if possible i'll take it plus its internals $130 and i'll front the shipping.

PM me. thanks

i'd say it would be different

Link to comment
https://www.sau.com.au/forums/topic/45748-wrecking-r32/#findComment-939147
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
    • Yes. You will need to get the original boost sensor and wire it in. That is.... if you plan to use a stock ECU - even a Nistuned ECU. The Nissan ECU will not operate correctly without it connected. And yes, it will do annoying stuff like you are experiencing. You will almost certainly be better off with some aftermarket ECU, than trying to hunt down rare sensors.
    • Ok so ABS/TCS is "not" the problem. Yeah i know now about the ABS with Nistune(i told that to the Nistune guy) but iam not 100% why or why i dont have ABS. ABS cube is in the engine (always has been) but i had braked couple of times rly hard and brakes just locked and scream. Does all Skylines have ABS cube? That boost sensor https://www.sau.com.au/forums/topic/367633-wtb-r34-gtt-turbo-pressure-sensor-pics-inside/ Is this it? I need to ask but i have a picture of engine bay and i do not see that (100% is not in that place) If i do not have this the car can do what mine is?(cutting around 4000 rpm) Here is the pic of my engine bay(only one i have) BUT i think i dont have that cuz loom was used from my RB20DE NEO and i know (obviously) that it does not have boost control or any wire to that...) so maybe that is the problem? (i dont know for 100% if that car where the engine is from had that)...but i dont have the loom from that
    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
×
×
  • Create New...