Jump to content
SAU Community

R32 wreaking, all parts

boostn32
 Share

Recommended Posts

Chris32 Veteran

Chris32

Posted
Posted

door/window seals, will take them if you have them

any of those trim clips with the screw in the middle

upper dash vents (the de-mister ones that sit just under front window)

pm me or email me - [email protected]

Chris

AzzurrA Grand Master

AzzurrA

Posted
Posted

I'm chasing:

*a coilpack or 2 (will get back to you about that as i'm checking all of mine today) *possibly an AFM...

*also need the trim for inside the boot.

*Do Still have the stock airbox as well?

*Drivers side Dash vent that goes above the climate control

*Drivers Side A-Pillar cover (added)

what sort of prices are you looking for for the above?

EDIT: Drivers Side A-Pillar cover added

Rayage Contributor

Rayage

Posted
Posted

I'm after:

- front indicators l/r (hopefully u have the clear indicators)

- front light cluster l/r (after the projector lights)

- clear protective cover for instrument cluster

- centre vents

- stock gear knob

Is this a GTS-t or GTR you're wrecking?

Can you post pics of your parts to verify condition? Purchase will obviously depend on the condition of parts.

Pekatu Community Regular

Pekatu

Posted
Posted

I am after, the interior temperature sensor, the rear window rubber, rear pods, passenger aircon vent, vents that blow onto window (if they are still straight, not twisted due to the heat) and so you have any aftermarket parts, boost guage, boost guage pod???

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      RB26DETT Sketchy boost mod?

      By GTSBoy · Posted

      There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • ARB26
      RB26DETT Sketchy boost mod?

      By ARB26 · Posted

      Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • GTSBoy
      Cas issue

      By GTSBoy · Posted

      The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Duncan
      RB26DETT Sketchy boost mod?

      By Duncan · Posted

      Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • nash47
      Cas issue

      By nash47 · Posted

      Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...