Jump to content
SAU Community

Sau Drag Day, 09-04-2016

Cadmoon

By Cadmoon,
in Events

 Share

Recommended Posts

Cadmoon Grand Master

Cadmoon

Posted
Posted

Date: 09-04-2016

Location: WILLOWBANK RACEWAY

Time: 12pm - 2pm

Cost: $60 Paid SauQLD member

$75 Non Paid SauQLD member

This admits the driver and 1 spectator, additional spectators will have to pay.

Spectator Cost: $20Adults, $18 Student with ID & Kids under 13 Free.

All are welcome to stay on after the QLD Event finishes & watch evening Test'N'Tune free.

To run you will need:

Requirements for Car

Helmet to Standard

Long Sleeve Shirt

Long Pants

Covered Shoes

Cars cannot run quicker than 10.00 sec

To run quicker you will need a current ANDRA Licence

All helmets need to be less than 12 years old from Date of Manufacture AND meet one of the following Standards:
SNELL SA2000
SNELL SA2005
SNELL 2000 / 2005
SNELL M2000
SNELL M2005
BS 6658-1985
SFI 41.2A
SFI 31.2A
AS/NZ 1698:2006

Also a lot of people think the helmets with "AS 1698" is the same as "AS/NZ 1698:2006" and its not, they're two different classifications.

13 January 2009 - The helmet regulations have changed, any ANDRA licenced holder is to abide by the current ANDRA rule book at any event. At Test'n'Tunes and Street Series events we will be allowing street vehicles (i.e - non ANDRA licence holders) to still use the AS1698 standard helmet.

Click this link for important new Safety Requirements to run at this event: http://www.willowban...=259&PageID=259

Passenger Rides (cars only)

  • Passenger MUST be 18 years old as a minimum - ID must be shown
  • $20 per passenger - paid at scrutineering
  • Paperwork to be completed at scrutineering
  • Only one passenger permitted in the vehicle at a time
  • Passenger must have approved helmet, long sleeves, long pants and covered shoes
  • Vehicle must have passenger seat, seat belt/harness and windows must be closed
  • The passenger is only permitted to ride in the vehicle he/she has signed the entry form for
  • Vehicles must have a known performance of no quicker than 12.00 seconds.

Payment Details:

Name: Skylines Australia Queensland Club

Bank: Westpac

BSB: 034 063

ACC: 354012

PAYMENT REFERENCE: Username&DragDay

Link to comment
https://www.sau.com.au/forums/topic/462341-sau-drag-day-09-04-2016/
Share on other sites
  • 4 weeks later...
  • 2 weeks later...
  • 4 weeks later...
  • 2 weeks later...
petes-performance Contributor

petes-performance

Posted
Posted

Damn was keen but not yet finished plus rego due today, house payment as well just bad timing for me. I was going for a look though. I know two people with r33's that will b joining soon...so let's all do our best to keep this thing going.

Cadmoon Grand Master

Cadmoon

Posted
  • Author
Posted

I reckon people might b looking to join a club the way cops r getting Hey should I have received something e.g.sticker or membership card for joining I only paid $20?

You should have, how long ago did you join?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      After market rear camber arm adjustment

      By Duncan · Posted

      Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • V35Newbie
      After market rear camber arm adjustment

      By V35Newbie · Posted

      I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • Duncan
      After market rear camber arm adjustment

      By Duncan · Posted

      You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • V35Newbie
      After market rear camber arm adjustment

      By V35Newbie · Posted

      I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • GTSBoy
      Unpeeling the Orange

      By GTSBoy · Posted

      Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...