Jump to content
SAU Community

1st SA post :P


Recommended Posts

  • 3 weeks later...

I'm up for a cruise, be nice if the rain would stay away!

I've installed my catch can, braided lines & anodised fittings, & finally transfered over to SA rego' with personal plates ;)

Transfer was fun NOT! but the only thing they knocked me back for was the MOMO! WTF!?!? I didn't argue though, it could've been a lot worse :) A quick swap back to the stockie & I was done ;) Then the c/can was then fitted :lol:

Joel,

Did you get a FMIC before & after dyno?

Link to comment
https://www.sau.com.au/forums/topic/479-1st-sa-post-p/#findComment-20060
Share on other sites

No I didn't Matt Unfortunately.

I know before on 12.5psi it made 152rwkw with a std intake & filter 3" full exhaust & fuel pressure bleed kit.

When I had the after dyno a quick check a boost up to 14psi she made only 153.8rwkw.

The fuel ratio was around 11:1 and I saw black smokes coming out the exhaust on occasions.

There was however a heap more in the mid range, boost seemed to come on a little slower also.

For some reason it was really flattening out up top. ?

BUT...

I got home wasn't really that happy honestly so I started to fiddle removed the origional cold air intake and plumbed a ~5" duct to the origional intake in the box, I also removed the AFM mesh.

I know the removal of the mesh & cold air intake made boost come on 300rpm earlier. I did the test on Flagstaff Hill in fifth gear from 2000rpm with a flat foot before & after in the same spot.

Drivability has improved heaps and up top is heaps better now.

For example 60kays in second with no throttle, i flatten it with the 225'50 F1's with 28psi in the tyres and it starts to spin the rears then it begins gripping after a second or two.

First gear is horrid like basically it will lite up with just a little more than 1/4 throttle.

I've only done it a couple of times but with a couple of v8 commo's i've clicked in to second a little to quick and it can spin for like 4 seconds in a straight line.

it is quite fun to drive now but I need to take it easy.

I will do a dyno run before I fit the VG30BB Turbo and boost that to 1 bar..

Oh yer..

I will have to meet up with Bugalugs again and see how he goes with the 255's.. ;)

Hello 190rwkw I hope...

Hrmmm that sounds like i've been thrashing the car..

I havn't but.... well ermmmm maybe a couple of times but only to see what she can do. :)

I can't wait for the up top performance of the VG30 terbs..

I can see what ppls mean how the std turbo's run out of puff.

Link to comment
https://www.sau.com.au/forums/topic/479-1st-sa-post-p/#findComment-20075
Share on other sites

Sounds good mate ;)

@ the 215+rwkw mark I removed my AFM screens & it didn't do a damn thing! I was way out of the AFM voltage range by that stage anyway.

You'll really start to see the benefit of the FMIC once the VG30 is fitted @ tuned.

It'd well worth getting your ECU re-tuned by Tilbrooks straight after the VG30 is installed (~$500 I think?) You'll really unlock the extra grunt then! Unfortunately Tim doesn't do stock ECU re-tuning so Tilbrook is your man.

With decent grip you'd give 'Bugs a good look @ your tail lights ;) With the VG30 & a re-tune you'd probably give me a good look too! Unless we do a 3rd gear rolling run :uh-huh: :)

I need some 265 FM901's, with the Falkens I get w/spin all through 2nd.

Link to comment
https://www.sau.com.au/forums/topic/479-1st-sa-post-p/#findComment-20118
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...