Jump to content
SAU Community

RB25DET Clear Timing Cover

Ree
 Share

Recommended Posts

Ree Newbie

Ree

Posted
Posted

Hi guys, quick question, purchased a clear timing cover. The cheaper one :( only to realise its not an exact duplicate of the factory cover. Has anyone used a cas gasket with this as you cannot get the cas gasket to fit, only behind the cas, as the cut outs are not there.. 

Has anyone ever brought one if them please. Some advice would be great

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • robbo_rb180
      R32 Gts+t Daily/street

      By robbo_rb180 · Posted

      Nice work on the shroud/ducting.  
    • ELFGT350
      Newbies

      By ELFGT350 · Posted

      Hi and best of luck with your car. Its a bit hard to tell how low the car is all round from that pic or if its been lowered or not. 90mm is a bit low on the front apron but it depends on the shocks & springs condition & whether or not its been lowered. Going to 19” wheels will give you 15-20mm depending on rubber but you might need new shocks. Mine -2005 are weeping fluid slightly but have lasted 19years!!. So if yours are original they need replacing anyway if they havent been touched before.
    • carnoobb
      Newbies

      By carnoobb · Posted

      Hi everyone, Recently got handed down a 2004 Skyline 350GT Coupe. I would like to change the wheels as the previous owner installed some weird ones. The current ones are 215/45ZR18, unsure of the offset, and sit pretty deep in. Would like to increase the ground clearance slightly as well as I need to get it roadworthy standard, currently sitting at 90mm. Was thinking that maybe I could kill 2 birds with 1 stone by getting new wheels.  Pictures of current wheels: https://imgur.com/bg1QMIu Any recommendations for the types of wheels I should be on the lookout for? Like the maximum and minimum offset, sidewall height, width, etc.  Sorry in advance if I'm noob, I do not know much about cars other than how to change the oil, a blown tyre and brakepads....
    • Lvonn1
      RB25DE Rebuild tolerances

      By Lvonn1 · Posted

      Hey MinKer, Where abouts did you get that table from ? 
    • joshuaho96
      Problem with 5th after manual swap on R32 GTS4

      By joshuaho96 · Posted

      Most likely your engine is toast, but also the R32 GTR has different ratios than the GTS4. In 5th it's basically the same, it's mostly 1st through 3rd that change. Stop trying to do WOT pulls before you make the engine entirely unsalvageable. Do a leakdown test and/or borescope the cylinders first. And a boost leak can overspeed a turbo. Make sure the turbo actually functions as intended.
×
×
  • Create New...