Jump to content
SAU Community

Recommended Posts

Hi guys

Has anyone noticed that on the stock R34 GTR rear muffler the right tip is almost not been used? Firstly there is almost no black exhaust deposit, and secondly, after a drive that right one is is only warm, while you can't touch the left one without getting burned.

r34gtrtipsb.thumb.jpg.d85dfcc167a16b3059e1bbbe26ede02c.jpg

Is there maybe a spring loaded flap in the box that only opens up the right section at a certain amount of counter pressure? Or what is the reason for that?

Link to comment
https://www.sau.com.au/forums/topic/484856-r34-gtr-stock-rear-muffler-insights/
Share on other sites

9 hours ago, silencium said:

Hi guys

Has anyone noticed that on the stock R34 GTR rear muffler the right tip is almost not been used? Firstly there is almost no black exhaust deposit, and secondly, after a drive that right one is is only warm, while you can't touch the left one without getting burned.

r34gtrtipsb.thumb.jpg.d85dfcc167a16b3059e1bbbe26ede02c.jpg

Is there maybe a spring loaded flap in the box that only opens up the right section at a certain amount of counter pressure? Or what is the reason for that?

There is a spring-loaded flap that only runs it at high enough flow rates. Nissan did this to reduce noise at low load/RPM while reducing backpressure at higher flow rates. 

23 hours ago, Duncan said:

You may well be the only person in the world still choking an R34 GTR with a standard exhaust!

It's not quite like that  ;) I've put that backbox on my daily S13. Got sick of the drone all aftermarket mufflers give, what is a problem of their design, because all of them are absorption type mufflers, and these just don't work for low frequencies. So that stock resonator type muffler (all oem mufflers are resonators) that is designed to work for a 300hp engine is the perfect solution for my daily. Also MOT is very strict in my country, so as a bonus its says "Nissan Calsonic" on the box  ;D

P_20230804_001617.jpg

  • Like 1
On 8/13/2023 at 2:04 PM, silencium said:

Thanks for your enlightenment. That's what I though and what makes sense  :)  Would you know of a picture or a diagram of that System by any chance?

Not sure there's any great pictures online, if you stick an inspection camera down the muffler you'll probably see it.

57 minutes ago, silencium said:

It's not quite like that  ;) I've put that backbox on my daily S13. Got sick of the drone all aftermarket mufflers give, what is a problem of their design, because all of them are absorption type mufflers, and these just don't work for low frequencies. So that stock resonator type muffler (all oem mufflers are resonators) that is designed to work for a 300hp engine is the perfect solution for my daily. Also MOT is very strict in my country, so as a bonus its says "Nissan Calsonic" on the box  ;D

P_20230804_001617.jpg

In that case, you just quadrupled your car's value :rofl:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Was going to say the car pulls up nicely everywhere, especially going into that last long right hander before the main straight. Looks like a lot of fun.
    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
×
×
  • Create New...